7.
Plug the PowerLifter into a proper outlet and turn ON the
Power Switch.
Make one slow forward and backward wet pass by push-
ing the SprayTrigger. Caution: Do not overwet.
Release the Spray Trigger and make one slow forward and
back pass over the same area to remove any residual dirty
water.
Repeat cleaning passes without pressing the Spray Trigger
until you can’t see any more water being suctioned up.
When cleaning job is complete, refer to
Maintenance/Storage.
Turn Power Switch OFF.
Unplug Power Cord from outlet and coil cord around
Power Cord Quick Release.
Remove Tank-in-Tank. Dispose of dirty water.
Rinse out Tank-in-Tank and re-seat the tank
onto the machine.
Wipe all exterior surfaces with a soft cloth.
Store cleaner in a protected, dry area.
When carpet is dry, vacuum again to remove hair and fuzz
that the PowerLifter may have loosened.
NOTE: Turn off machine and unplug from wall outlet.
Step on Handle Release pedal and recline Handle on floor
(see illustration).
Remove the Tank-in-Tank. Set aside (see illustration).
Normal Cleaning
1.
2.
3.
4.
6.
7.
5.
To Remove Broken Pump Belt
1.
2.
Maintenance/Storage
1.
2.
3.
4.
5.
Pump Belt Replacement
CAUTION:
PowerLifter uses
water and must not
be stored where
there is a danger of
freezing. Freezing
will damage internal
components and void
the warranty.
