622020
9
Zoom out
Zoom in
Previous page
1/14
Next page
9
Check the Drive Belt and Rotating Floor Brush regularly for
wear or damage. You should also remove string, hair, and
carpet fibers from the Brush and Brush ends. These can wrap
around the brush and hamper its ability to effectively clean
your carpet.
1. Unplug the unit, then press Handle Release Pedal to
position cleaner in full recline position.
2. Turn entire cleaner over to expose bottom of Powerfoot.
3. Using a Phillips head screwdriver, loosen the two
screws that secure the Brush Cover.
4. Remove the Brush Cover and check the Belt for damage or
wear, and the Brush for debris.
5. Check Belt carefully for wear, cuts or stressed areas. Inspect
entire Belt by rolling Floor Brush with the palm of your
hand several times in the direction of the motor pulley.
6. Check Air Passageway for obstructions. Remove debris from
this area.
Replace Drive Belt
1. Grasp the Brush at both ends and lift up.
2. Slide old Belt to clear motor pulley, remove Belt,
and discard.
3. Loop new Belt over motor shaft and stretch other end over
crown of Floor Brush.
4. Place Belt end of Brush into its slot and hold it in place with
your hand, while slowly pulling opposite end of Brush down
into its slot with your right hand.
5. Turn Brush by hand several times in direction of pulley. If
properly installed, the Belt will center itself on brush crown.
6. Replace Brush Cover. Be sure to align and insert front edge
of Brush Cover and secure with screws.
Replacement Belts
Use only BISSELL Replacement Belt (#32035, package of 2) in
your BISSELL Upright Vacuum Cleaner. You may purchase
these Belts:
at your local retailer.
with the order form in this User’s Guide.
or by calling
BISSELL Consumer Services
1-800-237-7691
Monday - Friday 8 a.m. – 7 p.m. EST
Saturday 9 a.m. – 2 p.m. EST
or from the BISSELL website –
http://www.bissell.com
Check Rotating Floor Brush and Drive Belt
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bissel Lift-Off 3554 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bissel Lift-Off 3554 in the language / languages: English as an attachment in your email.

The manual is 0,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info