716408
7
Zoom out
Zoom in
Previous page
1/9
Next page
EN
7
www.BISSELL.eu
C-1 Filling Formula & Water Tank
1. Remove tank by lifting it straight up, then
away from Lower Body.
2. Unscrew black cap located on bottom of
tank.
3. Fill with hand hot (not boiling) tap water
(140°F/60°C MAX) to WATER line. Fill rest of
tank with BISSELL 2X Formula to
FORMULA
line. Replace and tighten black cap.
Caution: Do not microwave or boil water
before filling.
4. Place tank on Lower Body.
C-2 Carpet cleaning
1. Plug into proper outlet.
2. Adjust Retractable Handle by turning
counter-clockwise and lifting handle up.
Turn clockwise to secure.
3. With foot, press red Power Pedal,
located on back of machine.
NOTE: Handle must be in the full upright
position before cleaning.
4. With foot, press grey Recline Pedal
located next to Power Pedal.
5. While pressing trigger, make one slow
forward wet pass and another one back.
Caution: Do not overwet.
6. Release trigger and make one slow
forward and backward pass over the same
area.
7. Repeat steps 5 and 6 until solution being
pulled up appears clean.
8. Empty Dirty Water Tank when dirty water
reaches FULL line, or when Formula and
Water Tank is empty.
C-3 Area rug cleaning
Important! Please check manufacturer’s tag
before cleaning area rugs for any specialized
cleaning instructions. We do not recommend
deep cleaning delicate, silk, wool, antique, or
area rugs without a manufacturer’s tag.
When cleaning area rugs, place rug on a
sealed surface and test a small, inconspicuous
area for colorfastness. Your carpet cleaner
should not be used on unsealed surfaces.
Follow carpet cleaning instruction in section
C-2. Keep foot of cleaner perpendicular to
rug’s edge with each cleaning pass to prevent
damage.
C-4 Empty the Dirty Water Tank
1. With foot, press the red Power Pedal to
turn off and unplug Power Cable from outlet.
2. Remove Dirty Water Tank from base of unit.
a. Release Dirty Water Tank latches (on
each side) by pulling up from bottom of
latch and then out.
b. Carefully remove tank by lifting up on
the tank handle.
3. Carry Dirty Water Tank to a toilet or sink.
To empty, pour out contents using opening
at back of tank.
4. Rinse tank thoroughly and replace on unit.
5. Refill Formula & Water Tank and continue
cleaning.
C-5 Cleaning after use
1. Unplug Power Cable from outlet.
2. Remove and rinse Dirty Water Tank
thoroughly.
3. Remove tank vent & foam filter (located
on top of tank) and rinse.
4. Clean nozzle window by lifting latch and
removing nozzle from machine. Rinse under
running water.
5. When finished replace nozzle and secure
with latch.
NOTE: For best results, it is recommended
that the nozzle is cleaned after each use.
6. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket.)
7. Replace Dirty Water Tank on base of
machine and secure with latches.
ATTENTION
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary vacuum
or deep cleaner may aggravate this condition.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bissel 48X4N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bissel 48X4N in the language / languages: English as an attachment in your email.

The manual is 1,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info