716412

Bissel 2009 - StainPro 6 Manual

7
Zoom out
Zoom in
Previous page
1/11
Next page
EN
7
www.BISSELL.com
C
Operations
Before you clean
1. Plan activities to give your carpet time to
dry.
2. Move furniture to another area if cleaning
an entire room (optional).
3. Vacuum area with a dry vacuum cleaner
before deep cleaning.
4. Plan your cleaning route to leave an
exit path. It is best to begin cleaning in the
corner farthest from your exit.
C-1 Filling the 2-in-1 water tank
1. Remove tank from base of machine by
lifting tank carry handle. Carry like a bucket
to the sink.
2. Pull upward on bottom edge of latch in the
back of tank to unhook and remove lid.
3. Pull up on bladder fill cover that says
“Fill Here”. Fill the bladder with hand hot
(60°C/140°F MAX) tap water. Do not boil
or microwave water as it can destroy the
bladder.
4. Using measuring cup provided, fill to
indicated fill line on measuring cup and pour
in to bladder.
NOTE: Always use genuine BISSELL 2X
formulas to maximize cleaning and for the
safety of your machine.
5. Push down on bladder fill cover to close.
6. Replace top lid back onto tank by
matching lid and tank edges, then lock latch
in place.
NOTE: Remember to secure lid and test to
make sure it is secure before picking up
tank.
7. Place tank into machine base, seating
firmly in place.
C-2 Carpet cleaning
1. Plug into a proper outlet.
2. Set ReadyTools dial to Floor Cleaning
setting.
3. Turn power on by pressing red power
pedal
on back of machine with your foot.
4. With your foot, press gray recline pedal
located on back of machine next to red
power pedal.
5. While pressing spray trigger, make one
slow forward wet pass and another back.
Caution: do not overwet.
6. Release spray trigger and make one slow
forward and backward pass over same area.
7. Repeat cleaning passes until solution
being suctioned up appears clean. Continue
passes without pressing spray trigger
until you can’t see any more water being
suctioned up. Repeated passes will help aid
in dry time.
NOTE: You may notice hair and debris
deposits on the carpet or in the tank that
were loosened by the cleaning action. This
debris should be picked up and thrown
away.
C-3 Area rug cleaning
Important! Please check manufacturer’s tag
before cleaning area rugs for any specialized
cleaning instructions. We do not recommend
deep cleaning delicate, silk, wool, antique or
area rugs without a manufacturer’s tag.
When cleaning area rugs, place the rug on a
sealed surface and test a small, inconspicuous
area for colorfastness. Your carpet cleaner
should not be used on unsealed surfaces.
Follow carpet cleaning instruction in section
C-2. Keep the foot of the cleaner perpendic-
ular to the rug’s edge with each cleaning pass
to prevent damage.
ATTENTION
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary vacuum
or deep cleaner may aggravate this condition.
Take care not to run over loose objects or edges
of area rugs. Stalling the brush may result in
premature belt failure.
Rotating brush inside-to avoid the risk of injury-
unplug before removing.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bissel 2009 - StainPro 6 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bissel 2009 - StainPro 6 in the language / languages: English as an attachment in your email.

The manual is 3,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info