4 5
3. If you need to exchange the unit, please
return it in its original carton, with a sales
receipt, to the store where you purchased it.
4. Should your humidifier require service,
please contact your local dealer.
ACCESSORIES FOR MODEL
• BWF7000 Water Purification Filter
• Bionaire
TM
Cleaning Solution
TECHNICAL SPECIFICATIONS
Input voltage: 220-240 V~ 50 Hz
Power consumption: 27 Watts
Holmes Products (Europe) Ltd. reserves the
right to change or modify any specifications
without notice.
FOR U.K. AND IRELAND ONLY
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by
a plug of the correct type. Please refer to
"Installation of a plug" below.
Installation of a plug applicable to U.K.
and Ireland
NOTE:If the terminals in the plug are not
marked or if you are unsure or in doubt about
the installation of the plug please contact a
qualified electrician.
If a 13A 3-pin plug is fitted, it must be an ASTA
approved plug, conforming to BS1363 standard.
Replacement 3A fuses must be BSI or
ASTABS1362 approved.
This product is fitted with a 13Aplug complying
to BS1363. If this plug is unsuitable or needs to
be replaced, please note the following: The
wires in the mains lead are coloured as such:
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug. Please
proceed as follows:
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wiremust be connected to
the terminal, which ismarked with theletter "N" or
is coloured BLACK.
DO NOTCONNECTeither of these wires to the
earth terminal in the plug.The earthterminal plug
is marked with theletter "E", or with the earth
symbol , or coloured GREEN,or GREEN and
YELLOW.
GUARANTEE
Please keep your receipt as this will be required
for any claims under this guarantee.
This appliance is guaranteed for 2 years after
your purchase as described in this document.
During this guaranteed period, if in the unlikely
event the appliance no longer functions due to a
design or manufacturing fault, please take it
back to the place of purchase, with your till
receipt and a copy of this guarantee.
The rights and benefits under this guarantee are
additional to your statutory rights, which are not
affected by this guarantee. Only Holmes
Products (Europe) Ltd. (“Holmes”) has the right
to change these terms.
Holmes undertakes within the guarantee period
to repair or replace the appliance, or any part of
appliance found to be not working properly free
of charge provided that:
• you promptly notify the place of purchase
or Holmes of the problem; and
• the appliance has not been altered in any
way or subjected to damage, misuse,
abuse, repair or alteration by a person
other than a person authorised by Holmes.
Faults that occur through, improper use,
damage, abuse, use with incorrect voltage, acts
of nature, events beyond the control of Holmes,
repair or alteration by a person other than a
person authorised by Holmes or failure to follow
instructions for use are not covered by this
guarantee.Additionally, normal wear and tear,
including, but not limited to, minor discoloration
and scratches are not covered by this guarantee.
The rights under this guarantee shall only apply
to the original purchaser and shall not extend to
commercial or communal use.
If your appliance includes a country-specific
guarantee or warranty insert please refer to the
terms and conditions of such guarantee or
warranty in place of this guarantee or contact
your local authorized dealer for more
information.
Waste electrical products should not be
disposed of with Household waste. Please
recycle where facilities exist. E-mail us at
enquiriesEurope@jardencs.com for further
recycling and WEEE information.
Holmes Products (Europe)
Limited
1 Francis Grove
London
SW19 4DT
UK
Before cleaning, Please note the following:
• DO NOT use soap, detergents, abrasives,
gasoline, glass or furniture polish, or boiling
water to clean any part of your Ultrasonic
Humidifier. These will interfere with the
proper operation of your unit and may affect
its appearance.
• DO NOT use sharp or metal objects to clean
mineral deposits in the reservoir. Contact
with sharp objects can result in damage to
the plastic.
• Mineral deposits should be soaked for up to
20 minutes in plain vinegar and water to
help with their removal.
• DO NOT clean any part of your humidifier in
the dishwasher.
Daily maintenance:
1. Before cleaning, switch off the unit and
unplug the unit from the electrical outlet.
2. Lift and remove the tank of the humidifier.
3. Drain and rinse the base and tank thoroughly
to remove any sediment or dirt. Wipe clean
and dry with a clean cloth or paper towel.
4. Refill the tanks as instructed in “Operating
Instructions”. Do not over fill.
5. If moisture forms on walls or windows in
your home, turn the humidifier off.
STORAGE TIPS
If you do not plan to use your unit for an
extended period of time, it is important that you
follow these instructions to help prevent
stagnation of water in the unit.
1. Turn the unit off and disconnect from the
outlet. Remove the water tanks, then empty
the tanks and the base completely. Clean
the humidifier as instructed in the cleaning
instruction section.
2. Dry the unit thoroughly. DO NOT leave any
water in the unit when storing.
3. Pack the humidifier in its original carton and
store in a cool, dry place.
SERVICE INSTRUCTIONS
1. DO NOT attempt to repair or adjust any
electrical or mechanical functions on this
unit. Doing so will void the warranty.
The insides of the unit contain no user
serviceable parts. Only qualified personnel
should perform all servicing.
2. Should the unit stop working, first check the
fuse in the plug (UK only) or fuse/circuit
breaker at the distribution board is operating,
before contacting the manufacturer or
service agent.
TROUBLE SHOOTING
PROBLEM
Control panel screen
is dark, no mist and
no airflow from the unit
Control panel screen is
illuminatedand flashing,
and there is no mist
There is not
enough mist
Mist has bad odour
Abnormal noise
CAUSE
Unit not turned on
Not connected to main supply
No water in the water tanks
The Mist Control is on the
Lo Setting
Resonance from the surface
bearing the unit
Scale covers the transducer
The water is too dirty or the water
in the tanks has been kept there
too long, so it’s not fresh
The machine is new or the water
is not clean
Resonance effect due to too little
water in the water tank
Resonance from the surface
bearing the unit
SOLUTION
Turn on unit
Connect to main supply
Refill water in water tanks
Change the Mist Control to Hi
Setting(see Mist Controlinstructions)
Place the unit on a steady surface or
on the ground
Clean the transducer softly with
a damp cotton ball. Transducer
surface is delicate, avoid applying
excessive pressure.
Clean the water tank, change to fresh,
clean water
Open the water tank and place the
appliance in a cool area for 12 hours.
Wash thetankout or change the water.
Refill water in the water tank
Place the unit on a steady surface or
on the ground
