740639
18
Zoom out
Zoom in
Previous page
1/23
Next page
14 15
Boost function
On models with 5 output levels, the highest output level is designed as a boost function with a brief runtime and
automatic fallback function (pursuant to EEC directive). The hood runs at maximum output for about 5 minutes
and then automatically switches back to a circulation output of less than 650 m³/h.
When is touched (reduce output)
a „1“ is displayed in the output display. This means: the lowest output level „1“ is automatically selected when this
control surface is pressed.
This control surface is also used to reduce the blower output. The output level is continuously decremented down
to the lowest output level when the control surface is depressed continuously.
Dwell timer
By enabling the dwell timer, the hood remains in operation at the programmed setting for an additional X minutes
and then automatically shuts off. During this time, the hood can be reset on demand to normal mode by disabling
this function.
The control sounds cannot be disabled.
INSTALLATION INSTRUCTIONS
Before starting the installation, it is essential that you review and observe the warnings in the „Safety Instruction“
section!
Proper installation - position and height
A headless extractor hood from Bielmeier can be installed by 2 people in a minimum of time. However, we
recommend having the installation performed professionally. Bielmeier is not liable for damage caused by
installation defects.
The hood should be installed on a masonry wall, but at least on a solid wall. Wooden walls, sheetrock structures,
etc. are unsuited, since these act as resonating cavities when the blower is in operation, therefore causing elevated
operating noise.
Contact your stove manufacturer to determine whether a extractor hood can operated above the stove. In order
to determine the ideal clearance between the hood and the stove top, the distance from the horizontal center of
the hood front should be measured to the stove top while the hood is hung. The following specifications generally
apply for headless extractor hoods if the manufacturer of the cooking equipment did not provide separate safety
clearances.
Clearance to electrical stove top
A minimum clearance of 650 mm must be adhered to between an electrical stove top and the horizontal center of
the extractor hood.
Clearance to gas stove top
A minimum clearance of 750 mm must be adhered to between an gas stove top (top edge of pot support) and
the horizontal center of the extractor hood.
Clearance to induction stove top
The clearance for induction stove tops is the same as for electrical stove tops.
If different cooking equipment is used, the larger specified clearance always applies.
Width of hood in relation to stove top
The width of the extractor hood and the width of
the stove top should be identical.
Cover the stove top while installing the hood to
avoid damaging the stove top.
Install the hood in a dry location without direct exposure to sunlight. Verify that the wall has the
proper strength and load-bearing capacity. Install the hood centered over the stove top
OVERVIEW OF YOUR EXTRACTOR HOOD
Overview of supplied scope
1 – NPower plug (E.-No. 950.001)
2 – Flexible hose/ exhaust hose (E.-No. 950.002)
3 – Control panel (E.-No. 950.003)
4 – Pipe adapter (E.-No. 950.004)
5 – Capacitor (E.-No. 950.005)
6 – Cover / circuit board (E.-No. 950.006)
7 – Circuit board (E.-No. 950.007)
8 – Magnet (E.-No. 950.008)
9 – Telescoping spring (E.-No. 950.009)
10 – Switch control (E.-No. 950.010)
11 – LED spotlight (E.-No. 950.011)
12 – Aluminum filter (E.-No. 950.012)
13 – Motor blower (E.-No. 950.013)
14 – Motor enclosure (E.-No. 950.014)
15 – Motor (E.-No. 950.015)
16 – Motor cover bracket (E.-No. 950.016)
17 – Cover (E.-No. 950.017)
18 – IR remote control (E.-No. 950.018)
19 – Operator panel (E.-No. 950.019)
20 – Glass insert 1 (E.-No. 950.020)
21 – Glass insert 2 (E.-No. 950.021)
22 – Hood body (E.-No. 950.022)
23 – Base wall sleeve(E.-No. 950.023)
24 – Telescopic wall sleeve (E.-No. 950.024)
25
Installation bracket for telescopic wall sleeve (E.-No. 950.025)
26 – Screw 6 x 80 mm & 8x80mm (E.-No. 950.026)
27 – Screw 4 x 6 mm (E.-No. 950.027)
28 – Electrical drive (E.-No. 950.028)
29 – Transformer (E.-No. 950.029)
30 – LED spotlight (E.-No. 950.030)
GB
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bielmeier BHG52 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bielmeier BHG52 in the language / languages: English, German as an attachment in your email.

The manual is 2,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info