528792
12
Zoom out
Zoom in
Previous page
1/44
Next page
12
every 15 seconds until it reaches the
minimum 1. If the pulse rate still stays
above the target value for more than
30 seconds the monitor will beep and
stop in order to protect the user.
To program time, distance, calories
and/or pulse rate, go through the
following procedure:
Once the heart rate program has been
selected and before pressing the
START / STOP key, press the ENTER
key to program the time limit using the
/ keys. Press ENTER again to
program the distance. Press the
ENTER key one last time to program
the calories. Press START / STOP to
start the exercise.
Your hands must be placed on the
pulse sensors (R) when using these
programs.
STEADY WATT RATE
PROGRAM
After entering your personal data the
LEDs for the various programs will
start flashing on the monitor.
MANUAL, PROGRAM, USER, H.RC
and WATT. Press the / keys to
select the WATT function and press
MODE. By pressing the / keys
you can program the watts to produce
for the exercise (between 10-350
Watt.). Select the watts and press
START / STOP to begin the exercise.
The exertion level for the exercise is
self adjusting based on the speed and
number of watts selected.
BODY FAT PROGRAM.-
This program is designed to calculate
the user’s body fat percentage and
then create specific load profiles.
Press the BODYFAT key and place
your hands on the pulse sensors (R)
(Hand-grips), as shown in Fig 6. The
selected user (U1~U4) will blink for 2
seconds, the LCD will display “-- --“
and after a few seconds the lower
screens on the display will show your
FAT%; BMI (Body Mass Index).
If the error code “E-1” appears then
this means that an error has
occurred, position your hands
correctly on the pulse sensors (R),
Fig 6.
"E-2" means that data is out of range.
Press BODYFAT again to exit this
function.
REFERENCE TABLE: BODY FAT
PERCENTAGE %
SEX /
FAT%
LOW LOW /
AVERAGE
AVERAGE
HIGH
MALE <
13%
13%-
25,8%
26%-30% >30%
FEMALE <23%
23%-
35,8%
36%-40% >40%
REFERENCE TABLE: BMI
THIN= NORMAL+ SLIGHTLY
OVERWEIGHT
OVER
WEIGHT
<18,5 =18,5~24,9 =25~30 <30
HAND-GRIP PULSE
MEASUREMENT
INSTRUCTIONS - USE
PULSE Hand-grip
On this model the pulse rate is
measured by placing both hands on
the sensors (R), located on the
handlebar, as shown in Figure nº 5.
When both hands are placed on the
sensors the heart symbol on the right-
hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will
be displayed.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BH Fitness H698 Monitor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BH Fitness H698 Monitor in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info