10
42a) connectors, located at the back
of the monitor (P), as shown in Fig 4.
FITTING THE ELECTRONIC
MONITOR.
Remove screws (C), Fig 4, from the
base of the monitor, then slide the
front of the monitor onto the plate on
the main post (17), Fig 4, making sure
not to snag any of the wires, fit the
screws (C) removed previously and
tighten securely.
TROUBLESHOOTING GUIDE
Problem: The display comes on but
only the Time function works
Solution:
a. Make sure that the connection cable
is connected.
Problem: The display does not come
on or the displayed segments are very
weak
Solution:
a. Check that the batteries are fitted
correctly.
b. Check the battery charge
c. If they are run down change them
immediately
Problem: Display segments of a
function read-out are not visible or
error messages for a particular
function appear.
Solution:
a. Remove the batteries for 15
seconds and then refit them correctly.
b. Check the battery charge If they
are run down change the batteries.
c. If the above steps do not help then
replace the electronic monitor.
(Transformer)
Problem: The monitor does not
switch on.
Solution:
a. Check the 220 V mains
connection
b. Check the output connection from
the transformer to the monitor.
c. Check the monitor cable
connections.
d. Check the cable connections for
the main post..
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
