534706
15
Zoom out
Zoom in
Previous page
1/75
Next page
3D Touch
Page 15
1.
2.
5. Print material
We support two print materials: PLA and ABS. Both have different properties and can be used in different build/support combinations. Typically, PLA
performs well as a build material with an ABS raft, and (if needed) ABS support.
PLA
PLA is a hard plastic with a low environmental impact. It is not a petrochemical - it is derived from renewable resources, such as starch. It is a
relatively new plastic and has excellent print characteristics.
As a build material: Good for large and small prints. Stable for 20 years up to 50 degrees Celsius
As a support material: Supports ABS well as it peels away easily. May be dissolved if required (see below).
PLA support can be dissolved by:
Leaving the model in an ultra-sonic with water and caustic soda. Time and concentration depends on the volume ofsupport removal tank
the material needed to dissolve.
Leave the model in water at 80°C for over 48 hours. The also provides this functionality.support removal tank
ABS
ABS is a well-known plastic with excellent toughness characteristics.
As a build
material:
Good for small prints with high toughness requirements. Do not print area larger than 100 mm square – ABS has relatively
high shrinkage on cooling, and some geometries for larger prints are prone to warping.
As a
support
material:
Supports PLA well as it peels away easily.
Material storage
All polymers degrade with time. The following conditions ensure the filament remains high quality:
Do not unpack until filament is needed.
Store at room temperature: 15-20 °C.
Keep away from UV light (e.g. sunlight).
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BFB 3DTouch at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BFB 3DTouch in the language / languages: English as an attachment in your email.

The manual is 11,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info