534707
28
Zoom out
Zoom in
Previous page
1/73
Next page
BFB-3000 Set Up and Operations Manual
Document No: D100253 28
6.8 Check the bed is referenced to the extruder nozzles
After levelling the bed, the nozzles must be set to the correct height, to ensure that the first
printed layer sticks properly (if the nozzle is too high the filament will not stick to the bed, if
the nozzle is too low the bed may block the nozzle).
Use the ‘Set Z Height’ function to accurately adjust the height of the nozzle for the first
layer.
Check the bed is fitted correctly (page 14)
Check the hot-end nozzles are clean (page 20).
Check the bed is level (page 21).
On the control panel select ‘Settings’, ‘Set Z Height’ function and press enter:
RUN FILE
EXTRUDER MAPPING
MANUAL MOVE
EXTRUDER CONTROL
HOME TOOL HEAD
>
SETTINGS
EXTRUDER OFFSETS
LEVEL BED
>
SET Z HEIGHT
SET BED TYPE
GENERAL SETTINGS
Observe the gap between the nozzle and bed from the front of the machine. Press
and hold the Z+/- buttons to move the bed.
Start with a gap between the bed and the nozzle. Move the bed towards the nozzle.
Observe the bed as it approaches the nozzle. Stop raising the bed as soon as the
nozzle touches the surface of the bed. If the bed goes too far, simply move the bed
back and repeat the approach.
The bed should just touch the nozzle, without any compression in the bed springs:
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BFB 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BFB 3000 in the language / languages: English as an attachment in your email.

The manual is 8,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info