Manual Beurer UB 55 (page 3 of 12) (English, German, Dutch, French, Italian, Spanish)

470463

Zoom out

Zoom in

1/12

ENGLISH

The heated underblanket is equipped with the BEURER SAFETY SYSTEM (BSS). This electronic sensor mechanism

protects the entire surface of the appliance against overheating by switching it off automatically in the event of

a fault.

Please note that the heated underblanket can not longer be used in this case for safety reasons.

How to use the heated underblanket

Spread the heated underblanket out flat on your mattress, beginning with the

bottom end. Then place your undersheet on the bed as usual, so that the

heated underblanket is between the mattress and sheet. Make sure that

the heated underblanket always lies flat and does not become rucked up or

creased during use. Check its position when making the bed and never switch

it on unless it is spread out flat.

We strongly recommend that you switch on the heated blanket approx. 40 minutes before going to bed (UB

30, 33, 34, 53, 55 and 70) and cover it with the bedclothes to prevent the heat from escaping. The UB 75

model is equipped with a rapid heating mechanism which shortens the warm-up time to approx. 15 min.

If there is a technical fault and the electric bed is automatically switched off by the Beurer Safety System (BSS),

the signal lamp will not go on even if the bed is switched on.

Caution: The electronic parts in the switch cause the switch to be slightly heated when the electric bed

is in use. The switch should never be placed on the bed or be covered by blankets, cushions or similar objects.

Temperature selection

The quickest way to warm up the underblanket is to switch it to the highest setting first. You can then turn it down

to setting 1 or 2 later on as required. In the case of models UB 30, 33, 34, 53 and 55 we recommend setting 1 if

you wish to leave the heating on during the night.

UB 70 and UB 75 are equipped with a sliding switch with 6 adjustable temperature settings. The quickest way to

warm up the underblanket is to switch it to the highest setting first (setting 6). Settings 1 - 3 are especially suitable

for night-time use.

Switch settings

UB 30, UB 33, UB 34, UB 53: UB 55: UB 70, UB 75:

0 = Off 0 = Off 0 = Off

1 = Minimum heat 1 = Minimum heat

(entire blanket) 1 = Minimum heat

2 = Medium heat 2 = Maximum heat

(entire blanket) 6 = Maximum heat

3 = Maximum heat F = Maximum heat

(foot area only) 1-6 = Individual heat settings

Additional note on UB 55

In the UB 55 model, you also have the option of heating the foot of the bed only. For this reason,

it is important to position the underblanket correctly on the bed, with the feeder cable outlet

roughly at the level of your shoulders or neck (see diagram).

Automatic cut-out UB 53, UB 70, UB 75

The electric beds UB 70, 75 can be set to switch off after 2, 6, 9 or 12 hours by using the second sliding switch

( ). The electric bed UB 53 switches off automatically after 90 minutes. While the electric bed is heated, the red

lamp on the switch is on. Once the selected switch-off time has lapsed, the electric bed stops heating and the red

lamp starts to flash. In order to re-heat the electric bed, first set the switch to position ”0” for 5 seconds (off) and

then select the desired temperature setting.

If the electric bed is no longer in use after it has been switched off (by the timer), it should be manually switched

off (setting ”0”) or the plug should be removed from the socket.

Cleaning and caring for your underblanket

Before cleaning the underblanket, always remove the plug from the socket. Minor stains can be removed with a

cloth or damp sponge, together with a little mild detergent if necessary. Please note that the heated underblanket

must not be dry cleaned.

In case of heavier soiling, the heated underblanket can be washed by hand at 30°C using a mild liquid detergent

(dosage according to manufacturer’s directions). It is advisable to clean the underblanket in the shower or bath

tub. Remember that the heated underblanket is an electrical appliance, and make sure that the switch does

not come into contact with water.

To make washing easier, fold the underblanket to a manageable size, then place it in the prepared detergent

solution and squeeze out the water afterwards by pressing down with the palms of your hands. To rinse the

underblanket, repeat the same procedure several times with clear water. After washing, squeeze out the moisture

once again with the palms of your hands. The underblanket must not be wrung out, spun or tumble-dried, nor

should it be put through a mangle or ironed. Under no circumstances should the underblanket be switched

on for drying purposes.

To dry the underblanket, hang it over a sturdy washing line or pole. Do not fasten it with pegs, etc. The underblanket

must not be used again until it is completely dry.

Additional note on UB 70, 75 for cleaning

Before washing the underblanket, disconnect the plug-in connector and with it the switch.

To release the plug-in connector, pull out the feeder cable (see diagram).

Now wash the underblanket as described above. Do not connect the feeder cable and switch

until the plug-in connector and heated underblanket are completely dry.

Protective covers

To protect the underblanket, a white cotton cover is also available from Beurer (size 80 x 150 cm, art. no. 160.100).

A moisture-proof protective cover is also available for incontinence sufferers (size 80 x 150 cm, art. no. 160.101).

The protective covers can be obtained from specialist retailers or directly from the Beurer customer service

department.

4 5

- nicht eingeklemmt werden.

- nicht scharf geknickt werden.

- nicht im feuchten Zustand eingeschaltet werden.

- nicht bei Hilflosen, Kleinkindern oder hitzeunempfindlichen Personen verwendet werden.

• Stechen Sie in das Wärme-Unterbett keine spitzen Gegenstände, wie z. B. Nadeln oder ähnliches.

• Während das Wärme-Unterbett eingeschaltet ist, darf

- kein großer oder schwerer Gegenstand, wie z. B. ein Koffer, daraufgelegt werden.

- keine Wärmequelle wie Bettflasche, Heizkissen oder ähnliches daraufgelegt werden.

- der Schalter nicht durch Decken, Kissen oder ähnliches abgedeckt werden oder auf dem Gerät liegen.

• Nicht an den Leitungen ziehen, drehen oder sie scharf knicken.

• Vor Gebrauch auf einem verstellbaren Bett oder bei geteilten Matratzen ist zu kontrollieren, ob das Wärme-

Unterbett nicht eingeklemmt ist.

• Der Schalter darf keiner Feuchtigkeit ausgesetzt werden.

• Das Gerät ist nicht für den Gebrauch in Krankenhäusern bestimmt.

• Reparaturen an Elektrogeräten dürfen nur von Fachkräften durchgeführt werden. Durch unsachgemäße

Reparaturen können erhebliche Gefahren für den Benutzer entstehen.

• Wenn der Schalter oder die Zuleitung des Wärme-Unterbettes beschädigt sind, dürfen sie nur vom Hersteller

ersetzt werden, da Sonderwerkzeuge erforderlich sind.

• Der Umwelt zuliebe bitte beachten: Verpackungsmaterial und ausgediente Geräte sollten der Wiederverwer-

tung zugeführt werden.

• Die von diesem elektrischen Produkt ausgehenden elektrischen und magnetischen Felder können unter

Umständen die Funktion Ihres Herzschrittmachers stören. Sie liegen jedoch weit unter den Grenzwerten:

Elektrische Feldstärke max. 5000 V/m, magnetische Feldstärke: max. 80 A/m, magnetische Flussdichte: max.

100 Mikro Tesla. Bitte befragen Sie deshalb Ihren Arzt und den Hersteller Ihres Herzschrittmachers vor der

Benutzung dieses Produktes.

• Dieses Gerät darf nicht von Kindern benutzt werden, es sei denn, die Regel- oder Steuereinheiten sind von

einem Elternteil oder einer Aufsichtsperson voreingestellt worden oder das Kind ist ausreichend eingewiesen

worden, wie es die Regel- oder Steuereinheiten sicher betreibt.

• Sollten Sie noch Fragen zur Anwendung unserer Geräte haben, so wenden Sie sich bitte an unseren Kunden-

service. Wir beraten Sie gerne.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Beurer UB 55 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,47 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Beurer UB 55

Beurer UB 55 User Manual - Dutch, Danish, Portuguese, Swedish, Norwegian, Finnish - 48 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Beurer UB 55 Manual

Product: