16
2.2 Power supply
To ensure adequate power at all times for good and powerful treatment of
the feet and nails, this instrument is provided with a permanently attached
power unit.
3. Application
3.1 General
– This device is intended for the treatment of hands (manicure) and feet
(pedicure) only.
– Make sure that the device is switched off beforehand.
– Select the desired attachment part and carefully press it onto the axle of
the device. To remove, pull apart the attachment and the device in oppo-
sing directions.
– Switch on the device by moving the sliding switch down (anti-clockwise
rotation, LED lights up red) or up (clockwise rotation, LED lights up
green).
– You can select the speed of the drive axle using the plus (+) and minus
(-) buttons. Start each application at a low speed and then increase as
required.
– Blue LEDs light up on the surface of the device depending on the se-
lected speed.
– All filing and callus attachments are coated with a sapphire grain. This
guarantees a long service life and ensures practically no wear.
– Do not press too hard and always carefully move the attachments to-
wards the area to be treated.
– Move the device towards the area to be treated and apply slight pressure
while slowly moving the device in circles.
– Please note that the callus attachments show reduced performance on
soaked or wet skin. For this reason, we ask that you do not soak the foot
in water before treatment.
– Do not remove all calluses to maintain natural skin protection.
– Ensure the axle can always rotate freely. The axle must not be perma
-
nently blocked, as otherwise the device will become too hot and may
become damaged.
– Apply moisturiser to the treated areas after each use.
