Manual Beurer LB 60 (page 9 of 56) (English, German, Dutch, French, Italian, Polish, Portuguese, Turkish, Spanish)

470483

Zoom out

Zoom in

1/56

3. Operation

3.1 Start-up

This appliance is used for the humidiﬁcation of environmental air.

• First remove all packaging materials and transport locking devices.

• Place the humidiﬁer on a ﬁrm, ﬂat and water-insensitive surface.

• Ensure that there is a limescale pad in the vaporizer cup (see Section „3.4 Limescale pad“). To do

this, remove both water tanks in turn, unlock the vaporizer by turning the turn-lock fastener out-

wards and remove the vaporizer. You can disengage and remove the steam nozzle by forcefully

turning it anticlockwise. Now place a limescale pad in the vaporizer cup so that it is spread out

ﬂat. Reassemble the humidiﬁer in reverse order and ensure that the steam nozzle and vaporizer

are securely locked.

• Fill the tanks as described in 3.2 and place them both on the humidiﬁer. Water can now enter the

base and into the vaporizer cup according to the „bird drinking principle“, and only as much water

ﬂows which is equal to the amount vaporized.

• Plug the power plug ﬁrmly into the socket outlet.

• Switch on the humidiﬁer - the signal lamps may ﬂicker just for a moment. Turn the humidistat to

the right until you hear a slight click. The humidity detected in the room by the humidiﬁer is excee-

ded with this click. It takes only a few minutes for the humidiﬁer to heat up and start operating.

• When the water tanks are empty - this will be the case after approx. 24 hours operation - the red

signal lamp lights and the humidiﬁer stops.

• If the water level drops below the minimum during operation, the heater will switch off and the red

lamp will light up.

• The humidiﬁer will operate as long as there is water in one of the two tanks or in the base. In some

circumstances, the tanks will not empty equally quickly! The humidiﬁer can be operated with

either one or both tanks.

3.2 Filling the water tanks

• First switch off the humidiﬁer and unplug it.

• Remove the tanks and open the tank covers. Fill the tanks with cold tap water. Then ﬁrmly screw

on the tank covers again anticlockwise. Ensure that the seal is ﬁtted and closes tightly.

• Now carefully ﬁt the tanks on the humidiﬁer and ensure that they ﬁt correctly, otherwise the humi

diﬁer cannot operate properly.

3.3 Using the aroma container

The aroma container allows you to release aromatic, herbal and other fragrances into the air.

• Switch off the humidiﬁer and allow the case and vaporizer to cool down.

• Carefully ﬁll the container with the substance selected. The container should not be ﬁlled higher

than half full.

• Now carefully place the container in the middle of the air ventilation grid of the vaporizer.

• After use, remove the container and clean it of residues using warm water.

3.4 Limescale pad

Because this humidiﬁer operates according to the vaporizer principle, none of the particles in the

water reach the respiratory air; they are trapped and remain in the vaporizer cup. The minerals

contained in the water accumulate on the large surface of the pad - chieﬂy limescale. The limescale

is easily removed from the humidiﬁer with the pad and deposits are reduced. The humidiﬁer also

operates without pads, but more frequent cleaning will then be required.

During operation, the water becomes very hot. If you want to remove the pad, ﬁrst let the water cool

down or use tongs.

The life of a pad will depend on the hardness of the water with which the humidiﬁer is operated.

In regions with average hardness, the pad should be changed after about 3 weeks of continuous

operation. Spare limescale pads can be obtained under Article No. 066.98 from the service address

or from your dealer.

To check when the pad should be changed, ﬁrst allow the water to cool and then remove the pad. If

it is hard and no longer ﬂexible, it must be exchanged. A further sign that the pad must be changed

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Beurer LB 60 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 0,42 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Beurer LB 60 Manual

Product: