Manual Beurer JIH50 (page 15 of 76) (English, German, French, Italian, Polish, Turkish, Spanish)

533571

Zoom out

Zoom in

1/76

Assembly

Remove the unit from the packaging.

• If not already

fitted, fit the

mesh atomiser

(3) onto the

neck of the

container (2),

and lock into

place by turn-

ing it clock-

wise until the

silver-coloured

contact elec-

trodes are facing downwards.

•

Place the

container with

fitted mesh

firmly onto the

housing (6) or

base of the

device, so that

you hear it click

into place on the

left and right.

•

Insert the batter-

ies.

Inserting the batteries

•

To open the battery compartment (7) on the under-

side of the device, apply light pressure and pull the

battery compartment cover in the direction of the

arrows, then fold the lid up.

•

Insert four batteries (type AA LR6).

•

Ensure that the poles of

the batteries are

touching their

respective poles in the

device (see illustration

on the bottom of the

casing).

•

Fold the battery com-

partment lid down again

and push it back in

place, in the opposite

direction to the arrows.

Note

•

When changing batteries, ensure that the medicine

container is completely empty, otherwise there is a

risk of leaks.

•

When the orange LEDs (4) light up, replace all four

batteries, because spraying becomes much less

effective when the batteries are weak.

•

You can operate the device for approx. 180min-

utes with new alkaline batteries.

•

This is sufficient for 5 – 9 uses of saline solution

(depending on the dose and duration of each use).

Operating the device with the power pack

Only connect the power pack (13) to the mains voltage

listed on the type plate.

•

Open the battery compartment lid to connect the

power pack (13).

•

Insert the power pack connector (8) into the con-

nection socket provided (15), and the power pack

(13) fully into a suitable socket.

Note

•

Ensure that there is a socket near to where the unit

will stand.

•

Lay the mains cable in such a way that no one can

trip over it.

•

To disconnect the nebuliser from the mains after

use, first switch off the device and then remove the

plug from the socket.

•

Do not remove the batteries when operating the

device with the power pack (13).

•

The power pack (13) cannot be used for charging

batteries.

7. Operation

1. Preparing the atomiser

•

For reasons of hygiene,

it is imperative that the

atomiser and accompa-

nying accessories are

cleaned and disinfected

after every use.

If the therapy requires

that various different medicines be inhaled in suc-

cession, ensure that the atomiser is rinsed after

every use. For details, see Cleaning and disinfec-

tion on page 16.

•

Remove the cover (1) from the device.

. Filling the atomiser

•

Open the medicine container

(2) by opening the clip, and fill

the medicine container with

an isotonic saline solution or

medicine. Do not overfill! The

maximum recommended fill

amount is 8 ml.

•

Use medication only on the advice of a physician,

and check the appropriate inhalation duration and

quantity for your needs.

•

If the recommended dose of the medicine is less

than 2 ml, top up this quantity to at least 4 ml us-

ing only isotonic saline solution. Viscous medicines

may also require dilution. Always follow the in-

structions of your doctor.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Beurer JIH50 in the language / languages: English, German, French, Italian, Polish, Turkish, Spanish as an attachment in your email.

The manual is 2,92 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Beurer JIH50

Beurer JIH50 User Manual - Dutch - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Beurer JIH50 Manual

Product: