Manual Beurer IH 21 (page 17 of 72) (English, German, French, Italian, Polish, Turkish, Spanish)

568809

Zoom out

Zoom in

1/72

If you have any queries, please contact the appropriate

local authorities.

10. Troubleshooting

Problem/

Question

Possible Cause/Remedy

The atomiser

produces

little or no

aerosol.

1. Too much or too little medicine in

the atomiser.

Minimum: 0.5 ml, Maximum: 8 ml.

2. Check that the nozzles are not

blocked If necessary, clean the

nozzle (e.g. by rinsing). Use the

atomiser again.

CAUTION: Only poke implements

through the fine holes from the

underside of the nozzle.

3. The atomiser is not held in an

upright position.

4. The medicine solution is unsuit-

able for nebulising (e.g. too thick).

The medicine solution should be

specified by the doctor.

Output is too

low.

Hose kinked, filter blocked, too

much inhalation solution.

Which

medicines are

suitable for

inhalation?

Consult your doctor.

Essentially all medicines that are

suitable and approved for device-

based inhalation can be inhaled.

Some inhala-

tion solution

remains in the

atomiser.

This is normal and occurs for techni-

cal reasons. Stop inhalation if you

hear a notable difference in the noise

of the atomiser.

What special

steps should

be taken for

babies and

children?

1. In babies, the mask should cover

the mouth and nose to guarantee

effective inhalation.

2. In children, the mask should also

cover the mouth and nose. Nebu-

lisation next to a sleeping person

is not suitable because insufficient

medicine reaches the lungs.

Note: Children should only use the

device with help and under supervi-

sion of an adult. Never leave a child

alone with the nebuliser.

Inhalation with

the mask takes

longer.

This is for technical reasons. Less

medicine is inhaled per breath

through the mask holes than using

the mouthpiece. The aerosol is

mixed with ambient air through the

holes in the mask.

Problem/

Question

Possible Cause/Remedy

Why do I need

to replace the

atomiser at

regular inter-

vals?

There are two reasons for this:

1. To guarantee a therapeutically

effective particle spectrum, the

nozzle holes should not exceed a

certain diameter. Due to the ther-

mal and mechanical stresses, the

plastic is subjected to a certain

amount of wear.

The atomiser [9] is

particularly sensitive. This can also

cause changes to the droplet com-

position of the aerosol, which has a

direct effect on the effectiveness of

the treatment.

2. You are also recommended to

replace the atomiser on a regular

basis for hygiene reasons.

Does each per-

son need their

own atomiser?

This is absolutely necessary for

hygiene reasons.

11. Technical specifications

Dimensions

(WxHxD) 300 x 180 x 100 mm

Weight 1.9 kg

Operating

pressure approx. 1.2 bar

Atomiser fill

volume max. 8 ml

Medicine flow > 0.2 ml/min.

Sound pressure < 60 dBA

(acc. to DIN EN 13544-1 section 26)

Mains

connection 230 V ~, 50 Hz; 180 VA

Housing material ABS

Operating

conditions

Temperature: +10 °C – +40 °C

Relative humidity: 10% – 95%

Storage and

transport

conditions

Temperature: -20 °C – +70 °C

Relative humidity: 10% – 95%

Atmospheric pressure: 500 – 1060 hPa

Subject to technical modifications.

Particle size diagram

All measurements were obtained with a sodium chlo-

ride solution using a laser diffraction method.

Cumulative distribution [–]

Particle size [μm]

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Beurer IH 21 in the language / languages: English, German, French, Italian, Polish, Turkish, Spanish as an attachment in your email.

The manual is 7,19 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Beurer IH 21

Beurer IH 21 User Manual - Dutch - 12 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Beurer IH 21 Manual

Product: