16
13 What if there are problems?
Faults Actions
Power LED does not light up
after switch-on
Check whether
š the relevant power supply unit is correctly connected.
š the batteries are full or the rechargeable battery needs charging or
is damaged.
On the monitor, an acoustic sig-
nal sounds and “out of range”
appears
Check whether
š the maximum range has been exceeded.
š the power supply unit for the camera is correctly connected.
š the camera is switched on.
š the batteries are full or the rechargeable battery needs charging or
is damaged.
The signal is weak, the connec-
tion keeps breaking up or there
is interference
š If another technical device such as a microwave is in the area
between the camera and the monitor, remove the device, or switch
it o.
š Check whether other factors, such as trees or anything else are
in the area between the devices, and change the position of the
devices until the monitor signals a connection.
š Check whether the camera and monitor are inside the maximum
receiving range.
Tuning the device signals.
If no transmission is possible
and only “OUT OF RANGE” is
shown, you have the option to
retune the device signals digit-
ally = pairing.
Position the monitor and camera 30 cm apart.
1. Turn on both units
2. Press and hold the “VOX” button on the monitor and night vision
button on the camera for 3 - 5 seconds.
3. The monitor displays “SINGAL SEARCHING” and the power LEDs
on the monitor and the night vision flash 3 times. Then release the
buttons.
4. Switch o camera and monitor.
5. When the camera and monitor are switched on again, the LINK LED
should glow green and a clear tone and good picture are transmitted.
On the monitor, there is no
acoustic signal
š Adjust the volume on the receiving device (monitor).
Camera or monitor switches
itself o
š Change the batteries or recharge the battery.
š If the operating display lights up, but only a noise signal is regis-
tered, the monitor could be in ECO mode. Press the
ECO
button to
switch on the screen.
We hereby guarantee that this product complies with the European R&TTE Directive 1999/5/EC.
Please contact the specified service address to obtain further information, such as the CE Declaration of
Conformity.
