551526
19
Zoom out
Zoom in
Previous page
1/22
Next page
18
1. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the MAXIMUM water level mark.
2. Press “ON/OFF” button on the control panel to begin the ice making cycle.
3. Select the ice cube size by pressing the “SELECT” button. If the room temperature is
lower than 15, it is recommended to select small ice cube in order to avoid ice sticking
together.
4. The ice making cycle lasts approx. 6 to 13 minutes, depending on seletion of ice cube size
and the room temperature. The recommended room temperature is 10 to 43
5. If water pump can’t inject water, the ice maker will stop automatically, and the Add Water
indicator will be on.Press “ON/OFFbutton, fill water up to the max. water level mark and
press “ON/OFF” button again to turn on the unit again.Allow the refrigerant liquid inside the
compressor at least 3 minutes to settle before restarting.
6. The unit stops when the ice basket is full and the “Ice Full” indicator will be on. Warning:
Direct sunlight or sunlight reflection may cause infared sensor malfunction. If the
unit doesn’t stop even ice cubes obstruct sensor, move the unit where no sunlight.
7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
If unit isn’t to be used, drain all the water and dry the tank.
USING YOUR ICE MAKER
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION:
“Add Water” indicator is
on.
Lack of Water.
Stop the ice maker, fill water, and
press “ON/OFF” button again to
restart the unit.
“Ice Full” indicator is on.
Ice is full in basket.
Remove ice from ice basket.
Continuous press “Select”
button 5 seconds, the unit
could make ice 10 cycles even
“Ice” indicator is on.
Ice cubes stick together.
The ice making cycle is too
long.
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small size ice cube selection.
Water temperature in inner
tank is too low.
Replace the water. Temperature
of water recommended at 8-32
Ice making cycle is normal
but no ice formed.
Room temperature or
water temperature in inner
tank is too high.
The room temperature should be
10-43, water temperature
should be 8-32
Refrigerant in cooling
system leaks.
Verify by a qualified technician.
Pipe in the cooling system
is blocked.
Verify by a qualified technician.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Betec 4060 - HZB-12A Compact Slim at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Betec 4060 - HZB-12A Compact Slim in the language / languages: German as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info