Manual Bestway SaluSpa (page 3 of 28) (English)

784589

Zoom out

Zoom in

1/28

IMPORTANT SAFETY INSTRUCTIONS

WARNING

IMPORTANT SAFETY INSTRUCTIONS

When using this electrical equipment, basic safety precautions should always be

followed, including the following:

READ AND FOLLOW ALL INSTRUCTIONS.

WARNING –

To reduce the risk of injury, do not permit children to use this

product unless they are closely supervised at all times.

A wire connector is provided on this unit to connect a minimum 8 AWG (8.37 mm2)

solid copper conductor between this unit and any metal equipment, metal enclosures

of electrical equipment, metal water pipe, or conduit within 5 feet (1.5 m) of the unit.

DANGER –

Risk of injury.

a) Replace damaged cord immediately.

b) Do not bury cord.

c) Connect to a grounded, grounding type receptacle only.

WARNING –

This product is provided with a ground-fault circuit-interrupter

integrated with the power plug at the end of the cord. The GFCI

must be tested before each use. With the product operating, push the test button on

the GFCI and the product should not operate. Push the reset button on the GFCI and

the product should now operate normally. When the product fails to operate in this

manner, there is a ground current flowing indicating the possibility of an electrical

shock. Disconnect the power until the fault has been identified and corrected.

DANGER –

Risk of Accidental Drowning. Extreme caution must be exercised to

prevent unauthorized access by children. To avoid accidents, ensure

that children cannot use this spa unless they are supervised at all times.

DANGER –

Risk of Injury. The suction fittings in this spa are sized to match the

specific water flow created by the pump. Should the need arise to

replace the suction fittings or the pump, be sure that the flow rates are compatible.

Never operate spa if the suction fittings are broken or missing. Never replace a

suction fitting with one rated less than the flow rate marked on the original suction

fitting.

DANGER –

Risk of Electric Shock. Install at least 5 feet (1.5 m) from all metal

surfaces. As an alternative, a spa may be installed within 5 feet of

metal surfaces if each metal surface is permanently connected by a minimum 8 AWG

(8.37 mm2) solid copper conductor to the wire connector on the terminal box that is

provided for this purpose.

DANGER –

Risk of Electric Shock. Do not permit any electric appliance, such as a

light, telephone, radio, or television, within 5 feet (1.5 m) of a spa.

WARNING –

To reduce the risk of injury:

a) The water in a spa should never exceed 104°F (40°C). Water temperatures

between 100°F (38°C) and 104°F (40°C) are considered safe for a healthy adult.

Lower water temperatures are recommended for young children and when spa use

exceeds 10 minutes.

b) Since excessive water temperatures have a high potential for causing fetal

damage during the early months of pregnancy, pregnant or possibly pregnant

women should limit spa water temperatures to100°F (38°C).

c) Before entering a spa, the user should measure the water temperature with an

accurate thermometer since the tolerance of water temperature-regulating devices

varies.

d) The use of alcohol, drugs, or medication before or during spa use may lead to

unconsciousness with the possibility of drowning.

e) Obese persons and persons with a history of heart disease, low or high blood

pressure, circulatory system problems, or diabetes should consult a physician

before using a spa.

f ) Persons using medication should consult a physician before using a spa since

some medication may induce drowsiness while other medication may affect heart

rate, blood pressure, and circulation.

WARNING:

TO AVOID ELECTRIC SHOCK, DO NOT USE THE SPA WHEN IT IS

RAINING.

WARNING:

Water attracts children; Always attach a spa cover after each use.

WARNING:

TO REDUCE THE RISK OF INJURY: Never add water that is higher

than 104°F (40°C) into the Spa.

CONSULT YOUR PHYSICIAN FOR

RECOMMENDATIONS.

CAUTION:

We strongly recommend not to unfold and inflate the spa if the ambient temperature

is below 59°F(15°C). We suggest inflating the spa indoors, and then continuing set

up outdoors. If the outdoor temperature is lower than 42.8°F(6°C), the spa heater

must always be on. In this mode, the Freeze Shield™ system can keep the internal

temperature between 42.8°F(6°C) and 50°F(10°C) to prevent damage, such as water

freezing in the pipes or the circulation system.

IMPORTANT:

If the Freeze Shield™ system isn’t working, alarms will pop up on

the spa. Be sure to check the status of your spa if the outdoor

temperature is below 42.8°F(6°C). In case of a long-term absence from home when

there is a risk of temperatures falling below 42.8°F(6°C), we strongly suggest

disassembling the spa and storing it following the storage procedure.

CAUTION:

Do not use the spa alone.

CAUTION:

Always enter and exit the spa slowly and cautiously. Wet surfaces are

slippery.

CAUTION:

To avoid damage to the pump, the spa must never be operated unless

the spa is filled with water.

CAUTION:

Immediately leave spa if the user feels uncomfortable or sleepy.

NOTE:

Please examine equipment before use. Notify Bestway® at the customer

service address listed on this manual for any damaged or missing parts at

the time of purchase. Verify that the equipment components represent the model that

you had intended to purchase.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Any changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bestway SaluSpa in the language / languages: English as an attachment in your email.

The manual is 2.99 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bestway SaluSpa Manual

Product: