752518
4
Zoom out
Zoom in
Previous page
1/32
Next page
4
LED Strip
Owner’s Manual
Model P5535
Parts reference overview
Follow the instructions to straighten the strip before installing to the SPA.
ATTENTION: DO NOT TWIST OR THE STRIP COULD BREAK
ATTENTION: DO NOT PULL THE STRIP FROM THE CONNECTION
WARNING: THIS ROPE LIGHT MUST NOT BE USED WITHOUT ALL GASKETS BEING IN PLACE.
LED strip, 433.92MHz
LED Remote Control, 433.92MHz, -10dBm
DC output transformer. Output:12VDC,1A
ON/OFF
(Auto-off in 2 hours)
Manual Color Change Auto Color Change
Brightness Adjustment
Flash Rate
WARNING
IMPORTANT: Do not put the
Remote Control in the water, if the
remote control falls into water,
take it out of the water
immediately.
Damage to the remote control
caused by immersion in the water
is not covered under your
warranty.
Battery Precaution
• Do not mix old and new batteries.
• Do not mix the different types of batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable
(Nickel - Cadmium) batteries.
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• Do not short-circuit the battery.
• Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.
• Rechargeable batteries are to be removed from this product before being charged.
• Never attempt to disassemble or open batteries as this can lead to electrolyte burns.
• Remove batteries from equipment which is not to be used for an extended period of time.
• Exhausted batteries are to be removed from this product.
• Do not dispose of product and its batteries in fire. Check your local regulations for proper disposal instructions.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or the similar.
• Keep batteries out of the reach of children.
• Only use 2x CR2032 batteries.
SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS - READ AND FOLLOW ALL INSTRUCTIONS.
Warning - Do not connect the chain to supply while it is in the packing or wound onto a reel.
Do not use the chain when covered or recessed into a surface. Do not open or cut the chain.
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged,
the luminaire shall be destroyed. The light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire shall be replaced.
Do not connect this chain electrically to another chain. The lamps are not replaceable.
SAVE THESE INSTRUCTIONS.
Software Version:
CPU-SOP8-64A8/B637 for LED strip
CPU-SOP14-3F2A(8586) for Remote Control
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bestway P5535 Led Light at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bestway P5535 Led Light in the language / languages: All languages as an attachment in your email.

The manual is 2,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info