686826
5
Zoom out
Zoom in
Previous page
1/12
Next page
5
POOL MAINTENANCE
Warning: If you do not adhere to the maintenance guidelines covered herein, your health might be
at risk, especially that of children. Pool water treatment is essential for the safety of the users.
Using chemicals inappropriately will cause property damage and personal injury.
NOTE: The pump is used to circulate the water and to filter small particles. In order to keep your
pool water clean and hygienic, you must also add chemicals.
1. It is recommended not to fill the pool with catchment water, drilling water, or drainage well
water: these waters generally contain polluted organic substances including nitrates and
phosphates. Filling pools with water from the public network is advised.
2. Always keep your pool clean and apply the correct pool chemicals. Unsanitary water is a
serious health hazard. It is recommended to use disinfectant, flocculant, acid or alkali chemicals
to treat your pool.
3. Clean the PVC liner regularly with non-abrasive brushes or a pool vacuum cleaner.
4. Throughout the season, the water filtration system must run long enough each day to clean the
entire volume of water in the pool.
5. Check the filter cartridge (or sand in a sand filter) regularly and replace dirty cartridges
(or sand).
6. Regularly check the screws, bolts and all the metal parts for rust. Replace if necessary.
7. If it rains, check that the water level is not higher than the specified level.
If water exceeds the specified levels, drain the pool to the specified level.
8. Do not use the pump when the pool is in use.
9. Cover the pool when not in use.
10. For pool water treatment, the pH value is very important.
ATTENTION: Do not leave the drained pool outside.
The following parameters ensure good quality water
ATTENTION: Do not leave pool unattended while filling with water.
Pool walls will rise as you fill with water.
1. Fill pool until water capacity is 80%, DO NOT OVERFILL as this could cause the pool to
collapse. In times of heavy rainfall you may need to empty some of the water to ensure the
level is correct.
2. When filling the pool is completed, check that the water is not collecting on any side to ensure
the pool is level.
IMPORTANT: If pool is not level, drain water and re-level ground by digging out. Never attempt
to move the pool with water in it, serious personal injury or damage to the pool may result.
WARNING: Your pool may contain a great deal of pressure. If your pool has any bulge or
uneven side, then the pool is not level, the sides may burst and the water may discharge
suddenly causing serious personal injury and/or damage to property.
Parameters Values
Water clarity clear view of the pool bottom
Colour of the water no colour should be observed
Turbidity in FNU/NTU max. 1,5 (preferably less than 0,5)
Nitrate concentration above that of fill water in mg/l max. 20
Total organic carbon (TOC) in mg/l max. 4,0
Redox potential against Ag/AgCI 3,5 m KCl in mV min. 650
pH value 6,8 to 7,6
Free active chlorine (without cyanuric acid) in mg/l 0,3 to 1,5
Free chlorine used in combination with cyanuric
acid in mg/l
1,0 to 3,0
Cyanuric acid in mg/l max. 100
Combined chlorine in mg/l max. 0,5 (preferably close to 0,0 mg/l)
Repair
Check pool for any leaks from valves or seams, check the ground cloth for any evident water loss.
Do not add chemicals until this has been done.
NOTE: In the event of a leak, patch your pool using the underwater adhesive repair patch
provided.
Refer to the FAQs for further information.
Dismantling
1. Unscrew the drain valve cap counter-clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the hose in the area where you are
going to drain your pool. (Check local regulations for drainage by-laws).
3. Screw the control ring of the hose adaptor clockwise onto the drain valve. The drain valve will be
open and water will start to drain automatically. Open the drain valve to the maximum position.
4. Deflate the top ring by squeezing the air valve.
5. When the top ring is fully deflated, press the top ring down, and tilt it to drain the pool easily.
Completely drain the water in the pool.
6. When draining is finished, unscrew the control ring to close the valve.
7. Disconnect the hose.
8. Screw the cap back onto the drain valve.
9. Air dry pool.
Storage and Winterization
1. Please remove all the accessories and spare parts of the pool and store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together,
fold pool carefully. If pool is not completely dry, mold may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF and
38ºC / 100ºF.
4. During the rainy season, pool and accessories should be stored as per above instructions also.
5. Improper draining of the pool might cause serious personal injury and/or damage to personal
property.
6. We strongly recommend the pool is disassembled during the off season (winter months).
Store in a dry location out of children’s reach.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bestway 57266 Fast Set at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bestway 57266 Fast Set in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bestway 57266 Fast Set

Bestway 57266 Fast Set User Manual - English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info