546711

Bestron DT48C Manual

28
Zoom out
Zoom in
Previous page
1/40
Next page
User’s instructions
28
English
14. Connect the blue wire, which comes from the ceiling, to the terminal block of the mounting plate.
Use the connection “N” on the right side of the block. That is the side closest to the hole.
15. Connect the brown wire, which comes from the ceiling, to the terminal block of the
mounting plate.
Use the connection “L” on the right side of the block. That is the side closest to the hole.
16. Hang the fan fully assembled with the canopy to the J-hook under the mounting plate. Now you have
your hands free to install the wiring. (See Figure 9A)
A B
N
L
Figure 9
17. Connect the yellow-green wire (which is disconnected in point 2) again to the earth screw and the rest
of the yellow-green wire on the inside of the canopy.
18. Connect the blue wire, which comes from the motor, to the terminal block of the mounting plate.
Use the jack “N” on the outside side of the block. That is the side closest to the edge. (See figure 9B)
19. Connect the blue wire, which comes from the motor, to the terminal block of the mounting plate.
Use the jack “L” on the outside side of the block. That is the side closest to the edge. (See figure 9B)
20. Cut the black wire, which comes from the motor, as far as possible. This wire should not be used.
21. Remove the fan of the J-hook, and slide the canopy over the two half loosened screws in the mounting
plate.
22. Turn the canopy slightly so the fan can not fall down any more. Then tighten the screws.
23. Now fasten the remaining 2 screws in the canopy.
24. Your fan is now hanging at 4 screws to the mounting plate and can be used.
25. Turn the power back on and check the fan by pulling the cord.
OPERATION - Controls
1. The sequence of operation for pull chain is : OFF-HI-MED-LOW
2. Push the slide switch DOWN for FORWARD and UP for REVERSE action of the blades
3. Even if your fan is mounted with blades more than 2.35m from the floor, be carefully to avoid placing
your raised arms or any object in the path of the blades.
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bestron DT48C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bestron DT48C in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 4,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info