614599
51
Zoom out
Zoom in
Previous page
1/85
Next page
1.0~3.0
Invisible zipper insertion
This foot is used to insert invisible zippers so
that they are covered by the seam, and thus
hidden.
Attach the invisible zipper foot to the machine.
Adjust needle center position and straight
stitch. Stitch length depends from the fabric.
Adjust 1,0 - 3,0 mm.
Place open zipper face - down on right side of
fabric as shown picture.
Place the fabric edge at the 5/8 inch marking
line on the needle plate surface.
Place the zipper 1/4 inch below raw edge of
garment.
With right-hand groove of foot over coil, stitch
zipper until the foot hits the slider. Remove the
garment from the machine.
To attach the other half of the zipper, place the
fabric edge on the 5/8 inch marking line on the
needle plate as shown in picture.
With the left-hand groove of foot over coil,
stitch zipper until the foot hits the slider.
Close zipper. Fold the fabric that the zipper is
on ride - hand side out of the way as shown in
picture.
Use a pin for fixing the fabric. Change to
regular sewing foot and saw as close as
possible with straight stitch against the zipper.
At last carry out tie off with some forward
and reverse stitches.
* The invisible zipper foot accessory is
optional. It is not included with this
machine.
Basic Sewing Procedures
3.5
50
1/4"
5/8"
Surface
Reverse
Surface
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bernina Bernette London-7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bernina Bernette London-7 in the language / languages: English as an attachment in your email.

The manual is 5,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bernina Bernette London-7

Bernina Bernette London-7 User Manual - German - 85 pages

Bernina Bernette London-7 User Manual - Dutch - 85 pages

Bernina Bernette London-7 User Manual - French - 85 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info