453315

Bernina Bernette 12 Manual

118
Zoom out
Zoom in
Previous page
1/136
Next page
EN
114
10 12 15
This foot is available as special accessory.
This foot is used to insert invisible zippers so
that they are covered by the seam, and thus
hidden. Attach the invisible zipper
foot to the machine. Adjust needle center
position and straight stitch. Stitch length
depends from the fabric. Adjust 1,0 - 3,0
mm. Place open zipper face - down on right
side of fabric as shown in picture 1.
Place the fabric edge at the 5/8 inch marking
line on the needle plate surface. Place the
zipper 1/4 inch below raw edge of garment.
With right-hand groove of foot over coil,
stitch zipper until the foot hits the slider.
Remove the garment from the machine.
To attach the other half of the zipper, place
the fabric edge on the 5/8 inch marking line
on the needle plate as shown in picture 2.
With the left-hand groove of foot over coil,
stitch zipper until the foot hits the slider.
Close zipper. Fold the fabric that the zipper
is on ride - hand side out of the way as
shown in picture 2.
Use a pin for xing the fabric. Change to
regular sewing foot and saw as close as
possible with straight stitch against the
zipper.
At last carry out tie off with some forward
and reverse stitches.
Please note:
No "S" marking is shown on the stitch length
dial by model 10.
Invisible zipper foot
502020.75.24_021V4D0101_1010_IM_bernette 10 12 15_EN_DE_NL_FR
… 118 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bernina Bernette 12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bernina Bernette 12 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 14,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info