614579
13
Zoom out
Zoom in
Previous page
1/52
Next page
12
Inserting a Bobbin
Insert the bobbin so that the thread runs clockwise.
Laying the thread into the slot
Pull the thread counter clockwise into the slot.
Pulling the thread under the spring
Pull the thread to the left under the spring until it lies in the T-shaped slit at the
end of the spring. The bobbin must turn clockwise.
Preparation - Sewing
turn power switch on (to «I»)
place empty bobbin on spindle
place thread on spool pin
attach appropriate spool disc; diameter of thread spool determines disc size
following the direction of the arrow take thread through the rear guide and
round the pre-tension stud
wind the thread two to three times around the empty bobbin and cut off any
excess thread on the thread cutter
push engaging lever against bobbin, the winder works automatically
the motor will stop automatically when the bobbin is full
Winding a Bobbin
Bobbin winding while sewing
place thread spool on vertical spool pin then, following the direction of the
arrow, take thread through the thread guide and around the pre-tension
stud
then proceed as mentioned above
Thread cutter
pull thread over thread cutter when removing the bobbin
033301.71.04_2014-02_Manual_B330_B350_PE_B380_EN
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bernina B330 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bernina B330 in the language / languages: English as an attachment in your email.

The manual is 8,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bernina B330

Bernina B330 User Manual - German - 50 pages

Bernina B330 User Manual - Dutch - 52 pages

Bernina B330 User Manual - French - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info