508645
119
Zoom out
Zoom in
Previous page
1/148
Next page
119
Troubleshooting
Fault Cause Repair
Screen does not respond
Calibration data incorrect
ECO function switched on
Re-calibrate the screen in the Setup Program
Turn off ECO function
Sewing computer fails to run or runs slowly
Plug not properly inserted
Sewing computer is kept in a cold room
Sewing computer is not switched on
Insert plug properly
Place it in a warm room for 1 hour before use
Turn on sewing computer (to «I»)
Needle breaks
Needle not correctly inserted
Fabric is pulled
Fabric was pulled when thick material used
Poor quality thread with knots
Tighten the needle clamp screw
Do not pull the fabric during sewing
Use the correct presser foot for thick material (e.g. Jeans
foot No. 8); use height compensating tool when sewing over
a thick seam
Use quality thread
Faulty Stitching
Remnants of threads between the tension discs of
upper thread tension
Raise presser foot.
Pull folded, thin fabric (do not use fabric edge) between the
tension discs and clean them by moving the fabric
sideways over the front and back of the thread tension disc
LED on the key does not light up
LED defective
ECO function switched on
Have the sewing computer checked by a dealer
Turn off ECO function
LED sewing light and free-arm light do not
light up
LED defect
ECO function turned on
Have the sewing computer checked by a dealer
Turn off ECO function
Attached presser foot not recognised
Sensors (of presser foot, sewing computer) may be dirty Clean sensors with a soft, slightly damp cloth
032298.53.04_1204_B820_EN
119


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bernina 820 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bernina 820 in the language / languages: English as an attachment in your email.

The manual is 27,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bernina 820

Bernina 820 User Manual - German - 216 pages

Bernina 820 User Manual - Dutch - 148 pages

Bernina 820 User Manual - French - 148 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info