489141
15
Zoom out
Zoom in
Previous page
1/194
Next page
14
Sewing preparation
turn power switch to «I» (on)
place empty bobbin on spindle
Then proceed as mentioned above.
push engaging lever A against bobbin
the winder works automatically
the Display to wind the bobbin is opened
move the round knob in the Display to the left/right or
turn the stitch width knob (see page 10)
the winding speed is altered
the motor will stop automatically when the bobbin is full
the Display is closed
remove bobbin and
pull the thread over thread cutter A to cut it
Winding a bobbin
Bobbin winding while sewing
attach foam pad on the vertical spool pin B
place thread on the vertical spool pin
following the direction of the arrow, take the thread through the thread
guide C and
guide around the pre-tension stud
A
A
place foam pad on the spool pin
place thread on the spool pin
attach appropriate spool disc
following the direction of the arrow, take the thread through the rear guide
and round the pre-tension stud
wind the thread two to three times around the empty bobbin
cut off any excess thread on the thread cutter A
C
Appropriate spool disc
Diameter of thread spool determines disc size. There must be no
gap between the disc and the spool.
B
It is recommended to reduce the winding speed when winding from
the vertical spool pin.
033527.53.04_2014-07_Manual_B580_EN
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bernina 580 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bernina 580 in the language / languages: English as an attachment in your email.

The manual is 17,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bernina 580

Bernina 580 User Manual - German - 194 pages

Bernina 580 User Manual - Dutch - 190 pages

Bernina 580 User Manual - French - 194 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info