Learning the radio finger-scan on the receiver7.4
Push the cover up to the 1. first notch or press the ON button to activate the
device.
The green LED is illuminated and indicates the identification mode.
Prepare the receiver (e.g. garage door operator) for learning in accordance 2.
with the operating instructions.
Pull a finger with a learned fingerprint over the finger sensor. 3.
The green LED will flash quickly as a positive acknowledgement and the radio
code that belongs to this fingerprint is sent. Afterwards, the green LED is
illuminated.
If necessary, press the ON button to extend the transmission time until the 4.
receiver has recognised the radio finger-scan.
Operation8
NOTE:
868 MHz: When used at the same time, GSM 900 mobile phones can affect the
range of the radio remote control.
Push the cover up to the 1. first notch or press the ON button to activate the
device.
The green LED is illuminated and indicates the identification mode.
Pull a finger with a learned fingerprint over the finger sensor. 2.
The green LED will flash quickly as a positive acknowledgement and the radio
code that belongs to this fingerprint is sent. Afterwards, the green LED is
illuminated.
The ON button can be used to transmit again within 15 seconds. As long as the
ON button is pressed, the radio code is transmitted, but for a maximum of
30 seconds. The green LED will flash very quickly during transmission.
If the timeout elapses during operation, the radio finger-scan will switch itself off
and you must begin again with step 1.
NOTE:
If a finger with an unlearned fingerprint is pulled over the finger sensor, the green
LED will go out and the red LED briefly flashes three times as a negative
acknowledgement. Afterwards, the green LED is illuminated again.
TR20B001 RE / 07.2009 21
ENGLISH