784247
7
Zoom out
Zoom in
Previous page
1/36
Next page
7
Installation
6006113_a – 01.06.2022
EN
3. Installation
3.1 Safety instructions for installation
DWARNING!
Hazard through disregard of the installation instructions!
This chapter contains important information for the safe
installation of the device.
Read through this chapter carefully before installing the
device.
Follow the safety instructions.
Carry out the installation as described.
yInstallation only by qualified specialist personnel.
D“1.2 Authorised target groups” (page 4).
yElectrical work must only be undertaken by qualified
electricians.
D“1.2 Authorised target groups” (page 4).
yThe hob and other parts that can be touched must be
allowed to cool prior to installation.
yStore the film or other parts of the packaging in a location
which is inaccessible to children.
yThe device must be in an undamaged and fault-free
condition prior to installation.
yCables must not be kinked, crushed or damaged.
yNever open the fan housing.
yIt is not permissible to attach further components
(e.g. panels, air ducts) to the device.
yThe power supply voltage must match the voltage
information quoted on the ratings plate.
D“2.3 Technical data” (page 6).
yEnsure that the power supply is stable and remains so
prior to the installation.
Connect the power supply only when instructed to do so
in the installation instructions.
Observe the safety information in the documentation for
the hob.
3.2 Requirements for the installation location
DWARNING!
Risk of death due to improper installation!
Disregard of the ambient conditions can lead to hazardous
situations, e.g. in the handling of electrical power or gas.
Make sure that the requirements for the installation
location are complied with.
yDo not install in potentially explosive atmospheres.
yMake sure that the building electrical supply is properly
earthed.
yThe power supply voltage present must match the
voltage information quoted on the ratings plate.
yThe customer must supply a means of connection to the
voltage supply in the installation area.
yThe customer must provide a separate connection point
with dedicated fuse for the hob.
yAn all-pole isolating device (with a contact gap of at least
3 mm) must be provided.
yUse of an extension cable for connection to the voltage
supply is not permitted.
yThe device must only be installed next to cabinets or
walls on one side in accordance with Type Y protection
against the risk of fire. Furniture or devices on the other
side must not be higher than the hob.
yThe distance from the device to a wall or furniture to the
side must be at least 40 mm.
yThe distance between the hob and cabinets above the
hob must be at least 600 mm.
yAir circulation must be ensured for sufficient ventilation of
the device:
yVentilation outlet opening at least 120 cm2 (e.g. in the
rear wall of the cabinet).
yMinimum gap beneath the device of 20 mm.
yDo not install in an enclosed cabinet.
yThe device must not be installed above the following
devices:
yOven without fan
yDishwasher
yClothes dryer
yThe work top must be installed with heat-resistant
adhesive (75 °C), sealed with special paint, silicone rubber
or cast resin.
yWall trim used in conjunction with installation must be
heat-resistant.
yThe device must remain accessible at all times for
maintenance work.
yIf necessary for the installation, only use suitable hob
protection grates or hob covers.
Please consult your dealer or customer services.
Country-specific, legal provisions must be observed.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Berbel BKF 90 iPP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Berbel BKF 90 iPP in the language / languages: English as an attachment in your email.

The manual is 7.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Berbel BKF 90 iPP

Berbel BKF 90 iPP User Manual - German - 36 pages

Berbel BKF 90 iPP User Manual - Dutch - 36 pages

Berbel BKF 90 iPP User Manual - French - 36 pages

Berbel BKF 90 iPP User Manual - Italian - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info