710252
9
Zoom out
Zoom in
Previous page
1/40
Next page
9
USB rechargeable blender Use instructions
EN
RECHARGE:
The plug for the USB cable is located on the base of the motor housing and is protected by a plastic cover, which
must be raised to insert the cable.
If the red light is on while turning on the appliance, it means that the battery is empty.
During charging the red light will ash until the charge is completed, when the charge is complete the light will
turn blue.
USAGE:
Before the rst use, clean the product as indicated in the paragraph “cleaning”.
Cut the ingredients into pieces of about 2 cm taking care to remove any very hard pits, shells and / or skin if the
ingredients are provided.
Put the ingredients in the container and make sure to add water and / or milk, taking care not to exceed the
maximum level (400 ml) indicated on the container. Failure to add liquid will affect the operation of the product.
Turning the motor housing upside down, screw it over the container.
Press the ON / OFF button and keep it pressed for about 3 seconds, until the blue light ashes, then the ap-
pliance starts to whisk, it is advisable to shake the blender during processing by holding it rmly, the light goes
off when the operation is nished.
Remove the motor body from the container then position the cover.
Note: After 4 consecutive work cycles, the operating light will start to ash, indicating that the product must be
switched off and let rest for at least 5 minutes to prevent the engine from overheating.
Warning: Before rst use, make sure the battery is fully charged.
CLEANING:
Fill the container with water, assemble the motor housing over the container and operate the product for about
20 seconds, the blades will be cleaned automatically. Dry carefully.
Take care that the blade is sharp.
The motor housing can be cleaned with a soft, slightly damp cloth.
TROUBLE SHOOTING :
Problem Possibile causes What to do
The appliance doesn’t work The product have been used for
too long time
The blade is blocked
The container is not well assem-
bled.
The battery is low power
Let the appliance rest for about
10 minutes than try again.
Remove the ingredients that block
the blades.
Try to assemble again.
Recharge the appliance .
The ingredients can’t be blended The container is too much or too
low loaded
The ingredients are too big or too
hard ;
Liquid has not been added
Pay attention to the min (100ml)
and max (400ml) levels shown on
the container.
Cut the ingredients in smaller
pieces.
Add water or other liquid.
The light ashes but the product
doesn’t work
Wrong assemble of the container
Low power battery
Container have been overloaded
Reassemble the container.
Recharge the battery.
Remove exceeding ingredients .
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beper BP630 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beper BP630 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Beper BP630

Beper BP630 Additional guide - English, German, French, Italian, Spanish - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info