710521

Beper 90520 Manual

10
Zoom out
Zoom in
Previous page
1/28
Next page
10
Drip Coffee maker Use instructions
BEFORE FIRST USE
Check that all accessories are complete and the unit is not damaged. Add water into water tank (4)
to the max level and brew water for several times without coffee powder, then discard the water.
Clean all detachable parts thoroughly with warm water.
USING YOUR COFFEE MAKER
1. Open the top lid and ll the water tank (4) with drinking water. The water level should not exceed
the maximum level marked in water gauge (5).
2. Place the funnel into the funnel support and make sure the funnel is assembled correctly. Then
put the lter correctly.
3. Add coffee powder into lter (1). Usually a cup of coffee need a level spoon of coffee powder, but
you may adjust according to personal taste. Then close the top lid.
4.Place the carafe on the keeping warm plate (7).
5. Plug the power cord into the outlet. The LCD will display will ash.
6. Press on/auto/off button once, the indicator in it will be illuminated red. The appliance will begin
working.
7. The brewing process can be interrupted by pressing the on/auto/off button twice at any time du-
ring operation, and the indicator in it will be illuminated blue, after about 15s, it will be extinguished.
The appliance will continue brewing once on/auto/off is pressed again.
8. Remove out carafe to serve when nish brewing (about one minute later after the coffee stops
dripping out.)
9. When the process is nished, if you do not want to serve immediately, keep the coffee maker is
energized, the coffee can be kept warm in the keeping warm plate (7). The appliance will be cut off
power automatically after 40 minute if it has not been manually disconnected at the completion of
brewing.
10. Always turn the coffee maker off and disconnect the power supply when not use.
AUTOMATIC START FUNCTION
If you do not want the coffee maker to start operation immediately, rst follow steps 1 to 5 of above
section, then you can set the automatic start function as follows:
1. Press PROG button one time, the word CLOCK is showed at the up-right corner on display.
2. Press the HOUR and MIN button continuously to set the present time (real clock)
3. Press PROG button again and the word TIMER shows on up-left corner of display.
4. Set the delayed starting time by pressing HOUR oand MIN button repetitively.
5. After setting the presetting time, press the PROG button once, the letter TIMER on the LCD will
disappear. The LCD will display the current clock. After 15s, the blue indicator in PROG button will
be extinguished.
6. Press the on/auto/off button twice, the indicator in it will illuminate blue and ash. The LCD will
display the current clock. You may see the automatic start time by pressing PROG twice.
Note: You may cancel the automatic start function by pressing on/auto/off button once to stop ma-
chine, if you want to brew coffee again immediately, you shall press on/auto/off button once again to
start brewing immediately. If you want to change the automatic start time, only following the above
1-4 steps again.
When the time is due the blue indicator in on/auto/off will stop ashing and illuminate red, then the
unit starts brewing. The appliance will be cut off power automatically after 40 minute if it has not
been manually disconnected at the completion of brewing.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beper 90520 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beper 90520 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info