545231
23
Zoom out
Zoom in
Previous page
1/63
Next page
23
Using the projector
Selecting an input source
The projector can be connected to multiple equipment at the same time.
When the projector is first turned on, it will attempt to reconnect with
the input source which was in use when the projector was last shut
down.
To select the video source:
Using the remote control or projector
1. Press SOURCE on the projector or remote control. A source
selection bar displays.
2. Press / until your desired signal is selected and press MODE/
ENTER.
Using the OSD menu
1. Press MENU/EXIT and then press / until the System Setup : Basic menu is highlighted.
2. Press to highlight Input Source and press MODE/ENTER. The source selection bar displays.
3. Press / repeatedly until your desired signal is selected and press MODE/ENTER.
Once detected, the selected source information will display on the screen for seconds. If there are
multiple pieces of equipment connected to the projector, you can go back to the source selection bar
again to search for other signals.
You can also rename the source:
1. Press MENU/EXIT and then press / until the System Setup : Basic menu is highlighted.
2. Press to highlight Source Rename and press MODE/ENTER. The Source Rename page
displays.
3. Press / / / until your desired character is selected and press MODE/ENTER.
If you want the projector to automatically search for the signals, select On in the System Setup :
Basic > Auto Source Search menu.
Fine-tuning the image size and clarity
NOTE: When
automatically
searching for a
valid input source,
the projector
cycles through
the available
signals following
the sequence
from top to
bottom as the
source selection
bar shows.
HDMI 1
HDMI 2
Video
S-Video
Component
PC
1. Adjust the projected picture to the size
that you need using the zoom ring.
2. Sharpen the picture by rotating the focus
ring.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BenQ W770ST at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BenQ W770ST in the language / languages: English as an attachment in your email.

The manual is 4,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BenQ W770ST

BenQ W770ST User Manual - German - 65 pages

BenQ W770ST User Manual - Dutch - 63 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info