214830
48
Zoom out
Zoom in
Previous page
1/53
Next page
48
Additional information
English
Troubleshooting
Problem Cause Remedy
The projector does not
turn on.
There is no power from the power
cable.
Plug the power cable into the AC inlet on the
rear of the projector, and plug the power cable
into to the power outlet. If the power outlet
has a switch, make sure that it is switched on.
(See page 19)
The power switch is not in the on
position.
Put the power switch in the on position. (See
page 19)
Attempting to turn the projector on
again during the cooling process.
Wait until the cooling down process has
completed.
The lamp cover is not securely
attached.
Correctly attach the lamp cover. (See page 44)
No picture.
The video source is not turned on or
connected correctly.
Turn the video source on and check that the
signal cable is connected correctly. (See page
16)
The projector is not correctly
connected to the input source device.
Check the connection. (See page 16)
The input signal has not been
correctly selected.
Select the correct input signal with the Source
buttons on the remote control or SOURCE on
the projector. (See page 19)
Image is unstable.
The connection cables are not securely
connected to the projector or the
signal source.
Correctly connect the cables to the
appropriate terminals. (See page 16)
Picture is blurred.
The projection lens is not correctly
focused.
Adjust the focus of the lens using the focus
ring. (See page 20)
The projector and the screen are not
aligned properly.
Adjust the projection angle and direction as
well as the height of this unit if necessary. (See
page 23)
Remote control does
not work correctly
The batteries are out of power.
Replace both of the batteries with new ones.
(See page 6)
There is an obstacle between the
remote control and the projector.
Remove the obstacle. (See page 6)
You are too far away from the
projector.
Stand within 8 meters (26.2 feet) of the
projector. (See page 6)
W20000-en.book Page 48 Monday, October 22, 2007 3:35 PM
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BenQ w 5000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BenQ w 5000 in the language / languages: English as an attachment in your email.

The manual is 4,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info