214479
26
Zoom out
Zoom in
Previous page
1/66
Next page
Operation26
Operation
Starting up the projector
1. Plug the power cord into the projector and into a
wall socket. Turn on the wall socket switch (where
fitted). Check that the Power indicator on the
projector lights orange after power has been
applied.
2. Slide the lens cover open. If it is closed, it could
become deformed due to the heat produced by
the projection lamp.
3. Press Power on the projector or remote
control to start the projector. As soon as the lamp
lights up, a "Power On Tone" will be heard. The
Power indicator light flashes green and stays
green when the projector is on.
The start up procedure takes about 30 seconds.
In the later stage of start up, a startup logo is
projected.
(If necessary) Rotate the focus ring to adjust the
image clearness.
To turn of the ring tone, see "Turning off the
Power on/off ring tone" on page 44 for details.
If the projector is still hot from previous activity, it will
run the cooling fan for approximately 90 seconds before
energizing the lamp.
4. If you are prompted for a password, press the arrow buttons to enter a six digit
password. See "Utilizing the password function" on page 28 for details.
5. Switch all of the connected equipment on.
6. The projector will start to search for input signals. The current input source being
scanned displays in the upper left corner of the screen. If the projector doesn't detect a
valid signal, the 'No Signal' message will continue displaying until an input source
signal is found.
Yo u c an also pr es s SOURCE on the projector or remote control to select your desired
input signal. See "Switching input signal" on page 31 for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range' displayed on a blank screen. Please change to an input signal
which is compatible with the projector's resolution or set the input signal to a lower setting.
See "Timing chart" on page 63 for details.
PUSH
I
I
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BenQ mp 723 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BenQ mp 723 in the language / languages: English as an attachment in your email.

The manual is 2,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BenQ mp 723

BenQ mp 723 User Manual - Dutch - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info