588384
57
Zoom out
Zoom in
Previous page
1/85
Next page
118
FARO ANTERIORE-SOSTITUZIONE LAMPADE
HEADLIGHT-REPLACING THE LIGHT BULBS
PHARE AVANT-REMPLACEMENT DES AMPOULES DU FEU
SCHEiNWERFER-AUSTAUSCH DER LICHTLAMPE
FAROL DELANTERO-SUSTITUCIOH BOMBELLAS
FARO ANTERIORE - SOSTITUZIONE LAMPADE
Operazione da eseguire a veicolo
fermo e chiave di accensione disinse-
rita. Non forzare i cavi elettrici.
Ad operazione ultimata, assicurarsi che
i cavi siano collegati correttamente.
Per effettuare l'operazione di sostituzione luci abbagliante e
anabbagliante, procedere come segue:
Rimuovi con le mani il cappuccio della lampada da sostituire,
passando da sotto lo scudo anteriore inferiore.
Con il veicolo di fronte, ruota in senso orario il portalampada.
Estrai e sostituisci la lampada difettosa premendola e
ruotandola di 30° in senso orario.
Per effettuare l'operazione di sostituzione luci di posizione è
sufficiente rimuovere il portalampada in gomma agendo sullo
stesso e successivamente sostituire la lampadina di tipo
tuttovetro difettosa.
Per rimuovere il portalampada non
tirare i cavi elettrici.
NOTA: Per agevolare queste operazioni si consiglia
di ruotare il manubrio dalla parte della lampadina
difettosa.
HEADLIGHT - REPLACING THE LIGHT BULBS
Perform this operation when the vehi-
cle is stationary and the ignition key is
in the OFF position. Do not force the
wires. After completing the operation, ensure
that the wires are properly connected.
To change the upper/lower beam bulbs, follow the
steps below:
Using your hands, remove the cap of the bulb to be changed,
from under the lower front shield.
With the vehicle in front of you, turn the bulb socket
clockwise.
Extract and change the defective bulb by pressing on
it and turning it by 30° in a clockwise direction.
To change the parking light bulbs, it is sufficient to
remove the rubber bulb socket. Afterwards, change
the defective all-glass bulb.
Do not pull the electrical cables when
removing the bulb socket.
NOTE: to facilitate this operation, turn the handlebar
to the side of the defective bulb.
MANUTENZIONE MAINTENANCE
Fig. 1
Fig. 2
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benelli Velvet 125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benelli Velvet 125 in the language / languages: English as an attachment in your email.

The manual is 3,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info