693641
18
Zoom out
Zoom in
Previous page
1/39
Next page
18
Arrangement with 3 m feeder
3000 4836 2456 2374 226
Arrangement with 4 m feeder
4000 5821 3441 2374 52
φ 2500 mm
(4000 dm
3
)
Arrangement with 5 m feeder
5000 6806 4426 2374 -122
* Dimension "A" is specified by the client when ordering, based on the specific boiler room design.
4.2. Control and safety elements of the boiler
The control and regulation of the boiler is governed by a control unit - see separate instruction manual.
Safety components that monitor the safe operation of the boiler:
The emergency thermostat is used to prevent the system from overheating. The manufacturer sets
the thermostat at 95°C, i.e. at a higher temperature than can be set on the boiler. The emergency
thermostat is positioned on the rear wall of the boiler in the CLIMATIX control unit cabinet.
Thermal protection of the motor (thermal contact) is part of both fuel feeder motors and is used to
protect them from overheating in the case of fuel feeder blockage. It also retroactively stops the fan so
as to avoid burning of fuel in the container in the event of a fault. During normal operation, the motor
working temperature is up to 85 °C - such warming does not mean a failure.
The turnstile is a device that mechanically separates the fuel between the screw conveyors (feeding
from the bunker + feeding into the boiler). In the event of re-ignition of fuel in the boiler feeding (e.g.
during long term power outage) the fuel in the tank does not ignite. Furthermore, the turnstile serves as
a partial fuel crusher. In the event of a longer piece reaching the turnstile, the turnstile crushes it into
smaller pieces.
The cover limit switch of the bunker feeder shuts down the screw feeder and fan when the cover is
open. After proper closure both will return to normal operation.
The emergency fire extinguishing system is another security feature preventing burning of fuel
through to the container. A temperature increase above 95 °C at the feeding out of the bunker results in
a thermostatic valve opening and the space being cooled with cooling water from the water main.
The firing flap is located between the second and the third draft in the top part of the finned heat
exchanger and serves to regulate the flue gas temperature at the boiler outlet.
When operating the boiler when the flue gas temperature is higher than 100 °C the firing valve must be
closed, i.e. the firing flap lever on the side of the boiler must be rotated as much as possible upwards
(forwards) and secured with a locking screw. When firing (with cold chimney) or during long term
operation of the boiler at lower output it is recommended to operate the boiler with the firing valve
slightly open so that the flue gas temperature does not drop below 80 °C. In this case, the firing flap
lever must be rotated downward (backwards) and secured by a locking screw.
4.3. Boiler accessories
Standard accessories:
Operating instructions and installation manual which includes a warranty card
Operating instructions of the boiler control unit
List of contracted service organizations
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benekov S51 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benekov S51 in the language / languages: English as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info