661648
14
Zoom out
Zoom in
Previous page
1/15
Next page
Statement for Industry Canada
Le fonctionnement de cet équipement est soumis aux conditions
suivantes:
(1) l’équipement concerné ne doit pas causer d’interférences, et
(2) il doit accepter toute interférence reçue, y compris les inter
-
férences risquant d’engendrer un fonctionnement indésirable.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
This Class B digital apparatus complies with Canadian ICES-003.
Zusätzliche Information
Zweckbestimmung des Produktes: Uhr mit Wecker Funktion inkl. Vib
-
rationskissen. Zulässige Betriebsbedingungen: Das Produkt darf nur
Innen verwendet werden. Reinigungshinweise: Nur mit trockenem
oder leicht feuchtem Tuch abwischen. Wartungshinweise: Akkus
können durch autorisiertes Fachpersonal ausgetauscht werden.
Bei Defekt des Blitzlichtes muss das Gerät eingeschickt werden.
Technische Daten: Betrieb mit 7.5V Netzteil inkl. 4 x AAA NiMH-
Akku (BE1350 Akkus optional) als Überbrückung bei Stromausfall.
Eingänge: Externer Trigger und Telefon (Nicht BE1350). Ausgänge:
Vibrationskissen. Hinweise zum Wiedereinsatz: Das Produkt ist nicht
für den Wiedereinsatz für eine andere Person vorgesehen.
BE1580: HMV 16.99.09.3021 BE1350: HMV 16.99.09.3023
BE1370: HMV 16.99.09.3022
For use in all EU countries
Hereby, Bellman & Symfon declares that this
Alarm Clock is in compliance with the essential
requirements and other relevant provisions of
directives: RED Directive 2014/53/EU
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause un
-
desired operation.
Warning: Changes or modications to this unit not expressly ap-
proved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the in-
structions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on acircuit dierent
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
For a complete Declaration of Conformity please contact:
info@bellman.com or call +46 31 68 28 20
Use and disposal of batteries
Replace only with the same or equivalent type
recommended by the manufacturer. Please
dispose of old, defective batteries in an environ-
mentally friendly manner in accordance with the relevant leg
-
islation in your country.
European oce
Bellman & Symfon Europe AB
Södra Långebergsgatan 30
436 32 Askim
Sweden
Phone +46 31 68 28 20
Fax +46 31 68 28 90
E-mail info@bellman.com
Asia Pacic oce
Bellman & Symfon Asia Ltd.
1115-16, Main Tower, GD Int’l Bldg
339 Huanshi Dong Rd
Guangzhou, China, 510095
Phone +86 20 8318 2950
Fax +86 20 8333 5528
E-mail info.cn@bellman.com
© 2018, Bellman & Symfon AB, all rights reserved. Bellman, Bellman & Symfon and
the Bellman & Symfon logo are registered trademarks of Bellman & Symfon AB.
REN: 0.1B
US: 1PNRG01BBERXTE1
a) This equipment complies with Part 68 of the FCC rules
and the requirements adopted by the ACTA. On the bot-
tom of this equipment is a label that contains, among
other information, a product identier in the format
US:AAAEQ##TXXX X. If requested, this number must be pro-
vided to the telephone company.
b) An applicable certication jacks Universal Service Order
Codes (USOC) for the equipment is provided (i.e., RJ11C) in
the packaging with each piece of approved terminal equip
-
ment.
c) A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply with
the applicable FCC Part 68 rules and requirements adopted
by the ACTA. A compliant telephone cord and modular plug
is provided with this product. It is designed to be connected
to a compatible modular jack that is also compliant. See in
-
stallation instructions for details.
d) The REN is used to determine the number of devices that
may be connected to a telephone line. Excessive RENs on
a telephone line may result in the devices not ringing in
response to an incoming call. In most but not all areas, the
sum of RENs should not exceed ve (5.0). To be certain of
the number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone
company. [For products approved after July 23, 2001, the
REN for this product is part of the product identier that has
the format US:AAAEQ##TXXXX. The digits represented by
## are the REN without a decimal point (e.g., 03 is a REN of
0.3). For earlier products, the REN is separately shown on the
label.]
e) If this alarm clock equipment causes harm to the telephone
network, the telephone company will notify you in advance
that temporary discontinuance of service may be required.
But if advance notice isn’t practical, the telephone company
will notify the customer as soon as possible. Also, you will be
advised of your right to le a complaint with the FCC if you
believe it is necessary.
f) The telephone company may make changes in its facilities,
equipment, operations or procedures that could aect the
operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to
make necessary modications to maintain uninterrupted
service.
g) Should you experience trouble with this equipment, please
contact your retailer for information about warranty and
service. If the equipment is causing harm to the telephone
network, the telephone company may request that you dis
-
connect the equipment until the problem is resolved.
h) Please follow instructions for repairing if any (e.g. battery
replacement section); otherwise do not alternate or repair
any parts of device except specied.
i) Connection to party line service is subject to state taris.
Contact the state public utility commission, public service
commission or corporation commission for information.
j) NOTICE: If your home has specially wired alarm equip
-
ment connected to the telephone line, ensure the instal-
lation of this alarm clock does not disable your alarm
equipment. If you have questions about what will disable
alarm equipment, consult your telephone company or a
qualified installer.
NOTICE: According to telephone company reports, AC electri
-
cal surges, typically resulting from lightning strikes, are very
destructive to telephone equipment connected to AC power
sources. To minimize damage from these types of surges, a
surge arrestor is recommended.
Applicable for Coin or Pay Phone Only
To comply with state taris, the telephone company must be
given notication prior to connection for customer-owned coin
or credit card phone. In some states, the state public utility
commission, public service commission or corporation com
-
mission must give prior approval of connection.
Additional regulatory information
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bellman BE1580 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bellman BE1580 in the language / languages: All languages as an attachment in your email.

The manual is 2,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bellman BE1580

Bellman BE1580 User Manual - English - 2 pages

Bellman BE1580 User Manual - English - 4 pages

Bellman BE1580 User Manual - German - 2 pages

Bellman BE1580 User Manual - Dutch - 4 pages

Bellman BE1580 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info