Manual Bellman BE1289 (page 4 of 11) (English)

747164

Zoom out

Zoom in

1/11

To test the interconnection:

1 Hold down the test button on the smoke alarm that is located farthest away from the

other units. Release the button when the smoke alarm starts to blink and chirp.

2 After a short delay, the interconnected smoke alarms will beep for 10 seconds and blink

for 5 minutes to conrm. To mute them, press the test button on each unit. If it doesn’t

work, see the 'Troubleshooting' section.

To clear the interconnection:

1 Remove the mounting bracket by turning it counter-clockwise to turn o the smoke alarm.

2 Hold down the test button as you turn on the unit by moving the switch clockwise.

Continue to hold down the test button until the red status LED on the front of the unit

goes out.

3 Press the test button again. The status LED will start to blink in red to show that it is

deleting the interconnection. When the status LED goes out, the interconnection is cleared.

Using interconnection

To interconnect your smoke alarms:

Start by selecting one of the smoke alarms that will function as the master unit. The other

alarms will function as slave units. Make sure all mounting brackets are tted.

1 Press the test button 3 times in quick succession on the selected master unit. The radio

LED on the back of the unit lights up in blue when it starts to transmit the pairing

signal.

2 Press the test button 3 times in quick succession on one of the slave units. The radio LED

on the back of the unit lights up in green when it has received the pairing signal. Repeat

this step to interconnect your other slave units.

Note: The master unit will timeout after 1 minute. Press the test button 3 times in quick

succession to exit and return to normal mode manually.

1 2

Master Slave

1 2 3

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bellman BE1289 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bellman BE1289 Manual

Product: