812754
7
Zoom out
Zoom in
Previous page
1/68
Next page
7
Bell res English
Installation instructions
1 INSTALLATION INSTRUCTIONS
1.1 GENERAL
The gas ! re must be positioned and connected as a “room sealed system” (balance
" ue) appliance by a “Gas Safe Register” registered gas installation engineer in
accordance with the following installation instructions, nationally and locally applicable
regulations (see “Technical Details / Regulations” at the rear of this manual). If you have
any queries regarding the installation, please consult your local gas company.
Important: Before beginning the installation, check that the details on the
rating plate correspond to the gas type and pressure to which
the appliance will be connected.
The appliance is factory set to the correct nominal heat input. The pilot light is set to the
correct level of consumption.
The appliance will be delivered from the factory with a Ø100 mm - Ø150 mm concentric
connection for extracting the " ue gases and supply of combustion air.
It is possible to install the gas ! re with either a wall or roof outlet.
The roof connection must be carried out using the concentric " ue system Ø100 mm -
Ø150 mm. The fumes are exhausted naturally to the outside environment through the
inner Ø100 mm pipe whereas the combustion air supply passes between the Ø100 mm
and Ø150 mm pipes.
The gas ! re can be installed in a completely sealed or mechanically ventilated house
without extra ventilation and/or fume extraction.
The gas ! re can be installed as an insertion into an existing open ! replace or as
a built-in appliance in a new ! replace.
In order to prevent the fi replace heating up excessively, it must be properly
ventilated by installing vents at the top and bottom of the ! replace.
The appliance is equipped with a convection casing. This brings the heated air into
the room. Optionally, the appliance can be equipped with a convection fan for faster
dissemination of this hot air.
If an existing chimney is to be used, please consult your installer ! rst. If the chimney
was previously used for a wood or coal ! re, then it should be cleaned by an expert.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bellfires Smart Bell 80-80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bellfires Smart Bell 80-80 in the language / languages: English as an attachment in your email.

The manual is 2.47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bellfires Smart Bell 80-80

Bellfires Smart Bell 80-80 User Manual - English - 36 pages

Bellfires Smart Bell 80-80 Installation Guide - German - 76 pages

Bellfires Smart Bell 80-80 User Manual - German - 36 pages

Bellfires Smart Bell 80-80 Installation Guide - Dutch - 68 pages

Bellfires Smart Bell 80-80 User Manual - Dutch - 36 pages

Bellfires Smart Bell 80-80 Installation Guide - French - 68 pages

Bellfires Smart Bell 80-80 User Manual - French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info