571719
19
Zoom out
Zoom in
Previous page
1/28
Next page
19
Bell res English
Instructions for use
Figure 4: Gas regulating block
2.4.3 Operation (Remote control)
Igniting the fi re
Open the gas supply valve in the gas pipe to the fi re.
Switch the hand-held transmitter to the
position.
On the hand-held transmitter, press the OFF and
(large fl ame) buttons simultaneously. A short tone
will signal the start.
Release the buttons. Short beeps will then follow until
the pilot light and main burner are ignited.
Once the main burner has been ignited, the fl ame
height will automatically rise to the maximum position.
Important: If the pilot fl ame goes out for any reason, wait for 5 minutes
before attempting to re-light it.
If the pilot light does not ignite after 3 ignition attempts;
close the gas tap and warn the fi tter.
Once the pilot light is burning, the main burner must ignite
within 10 seconds automatically.
If this does not happen, immediately close the gas tap and
warn the fi tter.
If the main burner ignites with a pop; immediately close the
gas tap and warn the fi tter.
Motor-knob
Microswitch8-wire Receiver Jack
Pilot gas adjustment screw
(Factory set) (Puncture the casing
with a small screwdriver)
Adjustment screw
Maximum burner pressure
(Factory set and sealed)
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bellfires CORNER BELL DERBY 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bellfires CORNER BELL DERBY 3 in the language / languages: English as an attachment in your email.

The manual is 0.76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bellfires CORNER BELL DERBY 3

Bellfires CORNER BELL DERBY 3 Installation Guide - English - 96 pages

Bellfires CORNER BELL DERBY 3 Installation Guide - German - 112 pages

Bellfires CORNER BELL DERBY 3 User Manual - German - 28 pages

Bellfires CORNER BELL DERBY 3 Installation Guide - Dutch - 96 pages

Bellfires CORNER BELL DERBY 3 Usermanual and installation guide - Dutch - 28 pages

Bellfires CORNER BELL DERBY 3 Installation Guide - French - 96 pages

Bellfires CORNER BELL DERBY 3 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info