Manual Bell Cantilever 200 (page 6 of 20) (English, French, Spanish)

773377

Zoom out

Zoom in

1/20

4english

Installation

1. Push both the red buttons at the same time

and spread the upper and lower frame apart.

Position the carrier on your vehicle. Figure A.

 Sedans and vehicles with trunks – Release

trunk tube from the snap clip by pushing

froward and upward. The arm should be

rotated up until it contacts the upper frame.

Rest the trunk tube on the vehicle and position

the rack so the bicycle support arms angle

slightly upward to the rear. Figure B.

 Minivans, SUVs, and most hatchbacks –

Leave the trunk tube attached to the lower

frame and set the

rack against the

rear of the vehicle

in a solid place that

allows the bicycle

support arms to

angle slightly upward from the rear. On these

vehicles the trunk tube remains clipped in a

lower position out of the way.

2. Attach top straps ‘U’ to leading metal

edge of trunk or hatch lid. Adjust the straps

so the rack stays in place on the car with

bicycle support arms angled slightly up from

horizontal. Figure C. Check that the carrier

is centered on your vehicle – adjust to center

as needed.

3. Attach lower straps ‘L’ to the bottom metal

edge of trunk or hatch lid, under the bumper,

or to the frame of the vehicle. Tension slightly.

Figure D.

4. Attach side

straps (7016046

and 7020149

only) ‘S’ to the

metal edge of the

trunk or hatch lid.

Tighten the side

straps. This will

also tighten the bottom straps. Figure E.

5. Tighten top straps while pushing forward

slightly on the rack. Figure F.

6. Check the arm position – they should angle

upward from the horizontal. Readjust lower and

upper straps if necessary. Tighten all straps one

more time. Figure G.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bell Cantilever 200 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0.48 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bell Cantilever 200 Manual

Product: