630724
15
Zoom out
Zoom in
Previous page
1/20
Next page
15
Making settings on the hob
Your hob is equipped with four gas burners. The following
information explains how to light the gas burners and set the
size of flame.
Lighting the gas burner
Always position the burner cap exactly over the burner cup.
Openings on the burner cup must always be unobstructed. All
parts must be dry.
1. Turn the rotary knob for the desired burner anti-clockwise to
the ignition position
ˆ. Ignition begins.
2. Press and hold the rotary knob for approximately 3-5
seconds. The gas burner ignites.
The safety ignition is activated. If the gas flame goes out, the
gas supply is automatically interrupted by the safety ignition
system.
3. Set the desired flame size. Between setting Ú Off and setting
¨, the flame is not stable. Therefore, always choose a setting
between
¨ large and © small flame.
4. If the flame goes out again, repeat the process from step 1.
5. To switch off the hotplate: Turn the rotary knob Ú clockwise to
the Off position.
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
: Caution:!
If you turn the rotary knob straight after switching the cooker off,
gas will escape. If you do not turn the knob to the ignition
position
ˆ ,the gas supply will be interrupted after 90 seconds.
No ignition occurs
If there is a power cut or if the ignition plugs are damp, you can
light the gas burners with a gas lighter or a match.
Warnings
It is normal to hear a soft whistling noise while the burner is
operating.
When first used, it is normal for the burner to give off odours.
This does not pose any risk and does not indicate a
malfunction. They will disappear in time.
An orange-coloured flame is normal. This is caused by the
presence of dust in the atmosphere, spilt liquids, etc.
If the burner flames are accidentally blown out, switch off the
burner operating control knob and do not try to relight it for at
least 1 minute.
A few seconds after the burner is switched off, a sound (thud)
will be produced. This is not a fault - this means that the safety
device is no longer operating.
Keep the burner as clean as possible. If the ignition sparkers
are dirty they will not light properly. Clean them periodically
using a small non-wire brush. Bear in mind that the ignition
sparkers must not suffer any serious impacts.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Belion GK604ZG20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Belion GK604ZG20 in the language / languages: English, Dutch as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Belion GK604ZG20

Belion GK604ZG20 Installation Guide - English, Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info