Manual BEKO WTV8725XCW1 (page 23 of 28) (English)

816203

Zoom out

Zoom in

1/28

23 / EN Washing Machine / User Manual

Loading door cannot be opened.

• Loading door lock is activated because of the water level in

the product. >>>Drain the water by running the Pump or

Spin programme.

• Product is heating up the water or it is at the spinning cycle.

>>> Wait until the programme completes.

• Loading door may be stuck because of the pressure it is

subjected to. >>>Grab the handle and push and pull the

loading door to release and open it.

• If there is no power, loading door of the product will not

open. >>>To open the loading door, open the pump filter

cap and pull down the emergency handle positioned at the

rear side of the said cap. See "Loading door lock"

Washing takes longer than specified in the user

manual.(*)

• Water pressure is low. >>>Product waits until taking in

adequate amount of water to prevent poor washing quality

due to the decreased amount of water. Therefore, the

washing time extends.

• Voltage is low. >>>Washing time is prolonged to avoid poor

washing results when the supply voltage is low.

• Input temperature of water is low. >>>Required time to

heat up the water extends in cold seasons. Also, washing

time can be lengthened to avoid poor washing results.

• Number of rinses and/or amount of rinse water have

increased. >>>Product increases the amount of rinse

water when good rinsing is needed and adds an extra

rinsing step if necessary.

• Excessive foam has occurred and automatic foam

absorption system has been activated due to too much

detergent usage. >>> Use recommended amount of

detergent.

Programme time does not countdown. (On models

with display) (*)

• Timer may stop during water intake. >>>Timer indicator

will not countdown until the product takes in adequate

amount of water. The product will wait until there is

sufficient amount of water to avoid poor washing results

due to lack of water. Timer indicator will resume countdown

after this.

• Timer may stop during heating step. >>>Timer indicator

will not countdown until the product reaches the selected

temperature.

• Timer may stop during spinning step. >>>Automatic

unbalanced load detection system is activated due to the

unbalanced distribution of the laundry in the product.

Programme time does not countdown. (*)

• There is unbalanced load in the product. >>>Automatic

unbalanced load detection system is activated due to the

unbalanced distribution of the laundry in the product.

Product does not switch to spinning step. (*)

• There is unbalanced load in the product. >>>Automatic

unbalanced load detection system is activated due to the

unbalanced distribution of the laundry in the product.

• The product will not spin if water is not drained completely.

>>>Check the filter and the draining hose.

• Excessive foam has occurred and automatic foam

absorption system has been activated due to too much

detergent usage. >>> Use recommended amount of

detergent.

Washing performance is poor: Laundry turns gray. (**)

• Insufficient amount of detergent has been used over a long

period of time. >>>Use the recommended amount of

detergent appropriate for water hardness and the laundry.

• Washing has been made at low temperatures for a long

time. >>>Select the proper temperature for the laundry

to be washed.

• Insufficient amount of detergent is used with hard water.

>>>Using insufficient amount of detergent with hard

water causes the soil to stick on the cloth and this turns

the cloth into gray in time. It is difficult to eliminate graying

once it happens. Use the recommended amount of

detergent appropriate for water hardness and the laundry.

• Excessive amount of detergent is used. >>>Use the

recommended amount of detergent appropriate for water

hardness and the laundry.

Washing performance is poor: Stains persist or the

laundry is not whitened. (**)

• Insufficient amount of detergent is used. >>>Use the

recommended amount of detergent appropriate for water

hardness and the laundry.

• Excessive laundry is loaded in. >>>Do not load the product

in excess. Load with amounts recommended in the

"Programme and consumption table".

• Wrong programme and temperature were selected.

>>>Select the proper programme and temperature for

the laundry to be washed.

• Wrong type of detergent is used. >>>Use original detergent

appropriate for the product.

• Excessive amount of detergent is used. >>>Put the

detergent in the correct compartment. Do not mix the

bleaching agent and the detergent with each other.

Washing performance is poor: Oily stains appeared

on the laundry. (**)

• Regular drum cleaning is not applied. >>>Clean the drum

regularly. For this procedure, please see "Cleaning the

loading door and the drum".

Washing performance is poor: Clothes smell

unpleasantly. (**)

• Odours and bacteria layers are formed on the drum as a

result of continuous washing at lower temperatures and/

or in short programmes. >>>Leave the detergent drawer

as well as the loading door of the product ajar after each

washing. Thus, a humid environment favorable for bacteria

cannot occur in the machine.

Colour of the clothes faded. (**)

• Excessive laundry was loaded in. >>>Do not load the

product in excess.

• Detergent in use is damp. >>> Keep detergents closed in

an environment free of humidity and do not expose them

to excessive temperatures.

• A higher temperature was selected. >>>Select the proper

programme and temperature according to the type and

soiling degree of the laundry.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WTV8725XCW1 in the language / languages: English as an attachment in your email.

The manual is 2.89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BEKO WTV8725XCW1

BEKO WTV8725XCW1 User Manual - Dutch - 28 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WTV8725XCW1 Manual

Product: