817022
12
Zoom out
Zoom in
Previous page
1/44
Next page
12 / EN
Washng Machne / User Manual
4.4 Installation
Preparation of the location and electrical, tap water and waste water installations at the
place of installation is the customer's responsibility.
Make sure that the water inlet and discharge hoses as well as the power cable are not
folded, pinched or crushed while pushing the product into its place after installation or
cleaning procedures.
The manufacturer shall not be held liable for damages that may arise from procedures
carried out by unauthorised persons.
Prior to installation, visually check if the product has any defects on it. If so, do not have
it installed. Damaged products cause risks for your safety.
4.4.1 Approprate nstallaton locaton
Place the product on a hard and level floor. Do not put it onto a carpet with high pile or
other similar surfaces.
If the washing machine and dryer are placed on top of each other, their total weight –
when loaded– amounts to 180 kilograms. Place the products on a solid and flat floor that
has sufficient load carrying capacity!
Do not place the product on the power cable.
Do not install the product in environments where the temperature falls below 0 ºC.
Leaving a gap at the sides of the machine is suggested to reduce vibration and noise
On a raised floor, do not place the product next to the edge or on a platform.
Do not place heat sources such as Hobs, Irons, Ovens, etc. on the washing machine and
do not use them on the product.
4.4.2 Removng packagng renforcement (if the product has)
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement that is
attached to the ribbon. Do not attempt this operation alone,
get help.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO WTK62054 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WTK62054 in the language / languages: English as an attachment in your email.

The manual is 4.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info