758341
9
Zoom out
Zoom in
Previous page
1/44
Next page
9 / EN Washing Machine / User’s Manual
Adjusting Rear Feet
When you turn the knob (visible in the circle)
in the direction of the arrow, the machine
will be elevated by 0.3 mm. When you turn
it in the opposite direction of the arrow, the
machine will be lowered by 0.3 mm.
You can check your machine‘s rear
and front feet via water gage for correct
adjusment.
Do not adjust the rear feet by using
chargeable devices. Use a screwdriver
instead.
Adjusting the feet with water level
You must remove the Detergent Drawer to
set the Water Level.
For the system to operate properly, the
bubble inside the Water Level must be in
the middle.
If the bubble inside the Water Level is on the
left, the pre-set right foot of the Washing
Machine must be adjusted.
If the bubble inside the Water Level is on the
right, the pre-set left foot of the Washing
Machine must be adjusted.
If the bubble inside the Water Level is at
the back, the pre-set front feet of the
Washing Machine must be turned to the left
(clockwise).
If the bubble inside the Water Level is at the
front, the pre-set front feet of the Washing
Machine must be turned to the right (anti-
clockwise).
4.1.7 Electrical connection
Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
Connection must comply with national
regulations.
The wiring for the electrical outlet circuit
must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit
Interrupter (GFCI) is recommended.
Power cable plug must be within easy reach
after installation.
If the current value of the fuse or breaker
in the house is less than 13 Amps, have a
qualified electrician install a 13 Amp fuse.
The voltage specified in the “Technical
specifications” section must be equal to
your mains voltage.
Do not make connections via extension
cables or multi-plugs.
A
CAUTION!
Damaged power cables must be replaced
by the Authorised Service Agents.
Electrical requirements
Before you insert the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily
accessible position.
Should the mains lead of the appliance
become damaged or need replacing at any
time, it must be replaced by a special purpose
made mains lead which can only be obtained
from a Authorised Service Agent.
B
WARNING!
This appliance must be earthed
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO WTIK84111F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WTIK84111F in the language / languages: English as an attachment in your email.

The manual is 8,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info