Manual BEKO WMY 91446 HLB1 (page 43 of 48) (English, German)

579709

Zoom out

Zoom in

1/48

43 / EN

Washing Machine / User’s Manual

clean the pump filter.

In addition, prior to transporting the machine (e.g.,

when moving to another house) and in case of freezing

of the water, water may have to be drained completely.

WARNING:

Foreign substances left in the pump

filter may damage your machine or may cause

noise problem.

WARNING:

If the product is not in use, turn the

tap off, detach the supply hose and drain the

water inside the machine against any freezing

possibility in the region of installation.

WARNING:

After each use close the supply hose

tap of the product.

In order to clean the dirty filter and discharge the

water:

1 Unplug the machine to cut off the supply power.

WARNING:

Temperature of the water inside the

machine may rise up to 90 ºC. To avoid burning

risk, clean the filter after the water in the machine

cools down.

2 Open the filter cap.

3 Some of our products have emergency draining

hose and some does not have. Follow the steps

below to discharge the water.

Discharging the water when the product has an

emergency draining hose:

a Pull the emergency draining hose out from its seat

b Place a large container at the end of the hose. Drain

the water into the container by pulling out the

plug at the end of the hose. When the container

is full, block the inlet of the hose by replacing the

plug. After the container is emptied, repeat the

above procedure to drain the water in the machine

completely.

c When dranng of water s fnshed, close the end by

the plug agan and fx the hose n ts place.

d Turn the pump filter to take it out.

If the holes on the bellow shown in the figure is

blocked, open the holes using a toothpick.

Foreign metal substances will cause rust stains in

the drum. Clean the stains on the drum surface by

using cleaning agents for stainless steel. Never use

steel wool or wire wool.

WARNING:

Never use sponge or scrub materials.

These will damage the painted and plastic

surfaces.

5.3 Cleaning the body and control panel

Wipe the body of the machine with soapy water or

non-corrosive mild gel detergents as necessary, and

dry with a soft cloth.

Use only a soft and damp cloth to clean the control

panel.

5.4 Cleaning the water intake filters

There is a filter at the end of each water intake valve

at the rear of the machine and also at the end of each

water intake hose where they are connected to the

tap. These filters prevent foreign substances and dirt

in the water to enter the washing machine. Filters

should be cleaned as they do get dirty.

1 Close the taps.

2 Remove the nuts of the water intake hoses to

access the filters on the water intake valves. Clean

them with an appropriate brush. If the filters are too

dirty, take them out by means of pliers and clean

them.

3 Take out the filters on the flat ends of the water

intake hoses together with the gaskets and clean

thoroughly under running water.

4 Replace the gaskets and filters carefully in their

places and tighten the hose nuts by hand.

5.5 Draining remaining water and cleaning

the pump filter

The filter system in your machine prevents solid items

such as buttons, coins and fabric fibers clogging the

pump impeller during discharge of washing water.

Thus, the water will be discharged without any

problem and the service life of the pump will extend.

If the machine fails to drain water, the pump filter is

clogged. Filter must be cleaned whenever it is clogged

or in every 3 months. Water must be drained off first to

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMY 91446 HLB1 in the language / languages: English, German as an attachment in your email.

The manual is 4,06 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BEKO WMY 91446 HLB1

BEKO WMY 91446 HLB1 User Manual - Dutch, French - 48 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WMY 91446 HLB1 Manual

Product: