676646

BEKO WMY 81413 LMB2 Manual

68
Zoom out
Zoom in
Previous page
1/81
Next page
68 / EN
Washing Machine / User’s Manual
3.AttachtheplasticcoverssuppliedintheUserManualbag
into the holes on the rear panel.
(P)
C
Keep the transportation safety bolts in a safe place to
reusewhenthewashingmachineneedstobemoved
again in the future.
Nevermovetheproductwithoutthetransportationsafety
boltsproperlyfixedinplace!
2.4 Connecting water supply
C
Thewatersupplypressurerequiredtoruntheproductis
between1to10bars(0.1–1MPa).Itisnecessaryto
have10–80litersofwaterflowingfromthefullyopen
tap in one minute to have your machine run smoothly.
Attachapressurereducingvalveifwaterpressureis
higher.
Ifyouaregoingtousethedoublewater-inletproduct
as a single
(cold)water-inletunit,youmustinstallthe
suppliedstoppertothehotwatervalvebeforeoperating
theproduct.(Appliesfortheproductssuppliedwitha
blind stopper group.)
A
WARNING: Modelswithasinglewaterinletshouldnot
beconnectedtothehotwatertap.Insuchacasethe
laundrywillgetdamagedortheproductwillswitchto
protectionmodeandwillnotoperate.
WARNING: Donotuseoldorusedwaterinlethoses
onthenewproduct.Itmaycausestainsonyourlaundry.
1.Connectthespecialhosessuppliedwiththeproductto
thewaterinletsontheproduct.Redhose(left)(max.90
ºC)isforhotwaterinlet,bluehose(right)(max.25ºC)is
forcoldwaterinlet.
A
WARNING: Ensurethatthecoldandhotwater
connectionsaremadecorrectlywheninstallingthe
product.Otherwise,yourlaundrywillcomeouthotatthe
endofthewashingprocessandwearout.
2.Tightenallhosenutsbyhand.Neveruseatoolwhen
tightening the nuts.
3. Open the taps completely after making the hose
connectiontocheckforwaterleaksattheconnection
points.Ifanyleaksoccur,turnoffthetapandremovethe
nut.Retightenthenutcarefullyaftercheckingtheseal.To
preventwaterleakagesanddamagescausedbythem,
keepthetapsclosedwhenthemachineisnotinuse.
2.5 Connecting to the drain
• Theendofthedrainhosemustbedirectlyconnectedto
thewastewaterdrainortothewashbasin.
A
WARNING: Yourhousewillbefloodedifthehose
comesoutofitshousingduringwaterdischarge.
Moreover,thereisriskofscaldingduetohighwashing
temperatures!Topreventsuchsituationsandtoensure
smoothwaterintakeanddischargeofthemachine,fix
the end of the discharge hose tightly so that it cannot
come out.
• Thehoseshouldbeattachedtoaheightofatleast40
cm, and 100 cm at most.
• Incasethehoseiselevatedafterlayingitonthefloor
level or close to the ground (less than 40 cm above the
ground),waterdischargebecomesmoredifficultandthe
laundrymaycomeoutexcessivelywet.Therefore,follow
the heights described in the figure.
100cm
40cm
• Topreventflowingofdirtywaterbackintothemachine
andtoallowforeasydischarge,donotimmersethehose
endintothedirtywaterordonotdriveitinthedrainmore
than15cm.Ifitistoolong,cutitshort.
• Theendofthehoseshouldnotbebent,itshouldnotbe
steppedonandthehosemustnotbepinchedbetween
the drain and the machine.
• Ifthelengthofthehoseistooshort,useitbyadding
anoriginalextensionhose.Lengthofthehosemay
notbelongerthan3.2m.Toavoidwaterleakfailures,
theconnectionbetweentheextensionhoseandthe
drainhoseoftheproductmustbefittedwellwithan
appropriate clamp as not to come off and leak.
2.6 Adjusting the feet
A
WARNING: Inordertoensurethattheproduct
operates more silently and vibration-free, it must stand
levelandbalancedonitsfeet.Balancethemachine
byadjustingthefeet.Otherwise,theproductmay
move from its place and cause crushing and vibration
problems.
1. Loosen the lock nuts on the feet by hand.
2.Adjustthefeetuntiltheproductstandsleveland
balanced.
3.Tightenalllocknutsagainbyhand.
… 68 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO WMY 81413 LMB2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMY 81413 LMB2 in the language / languages: German, Dutch, French as an attachment in your email.

The manual is 5,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info