Manual BEKO WMY 71483 LMB2 (page 33 of 36) (English, German)

579423

Zoom out

Zoom in

1/36

33 / EN

Washing Machine / User’s Manual

If the machine fails to drain water, the pump filter is clogged.

Filtermustbecleanedwheneveritiscloggedorinevery3

months. Water must be drained off first to clean the pump

filter.

Inaddition,priortotransportingthemachine(e.g.,when

movingtoanotherhouse)andincaseoffreezingofthe

water,watermayhavetobedrainedcompletely.

WARNING: Foreign substances left in the pump

filter may damage your machine or may cause noise

problem.

WARNING: If the product is not in use, turn the tap

off, detach the supply hose and drain the water inside

the machine against any freezing possibility in the

region of installation.

WARNING: After each use close the supply hose tap

of the product.

In order to clean the dirty filter and discharge the

water:

1 Unplug the machine to cut off the supply power.

WARNING: Temperatureofthewaterinsidethe

machinemayriseupto90ºC.Toavoidburningrisk,

clean the filter after the water in the machine cools

down.

2 Open the filter cap.

3 Someofourproductshaveemergencydraininghoseand

somedoesnothave.Followthestepsbelowtodischarge

the water.

Discharging the water when the product has an

emergency draining hose:

a Pull the emergency draining hose out from its seat

b Place a large container at the end of the hose. Drain the

water into the container by pulling out the plug at the end

of the hose. When the container is full, block the inlet

of the hose by replacing the plug. After the container is

emptied,repeattheaboveproceduretodrainthewaterin

the machine completely.

c When draining of water is finished, close the end by the

plugagainandfixthehoseinitsplace.

d Turnthepumpfiltertotakeitout.

RepeatDrumCleaningprocessinevery2months.

Use an anti-limescale suitable for the washing

machines.

Aftereverywashingcheckthatnoforeignsubstanceisleft

in the drum.

If the holes on the bellow shown in the figure is blocked,

open the holes using a toothpick.

Foreign metal substances will cause rust stains in the

drum.Cleanthestainsonthedrumsurfacebyusing

cleaningagentsforstainlesssteel.Neverusesteelwool

or wire wool.

WARNING: Neverusespongeorscrubmaterials.

Thesewilldamagethepaintedandplasticsurfaces.

5.3 Cleaning the body and control panel

Wipe the body of the machine with soapy water or non-

corrosivemildgeldetergentsasnecessary,anddrywitha

soft cloth.

Use only a soft and damp cloth to clean the control panel.

5.4 Cleaning the water intake filters

Thereisafilterattheendofeachwaterintakevalveatthe

rear of the machine and also at the end of each water intake

hosewheretheyareconnectedtothetap.Thesefilters

preventforeignsubstancesanddirtinthewatertoenterthe

washing machine. Filters should be cleaned as they do get

dirty.

1 Closethetaps.

2 Removethenutsofthewaterintakehosestoaccess

thefiltersonthewaterintakevalves.Cleanthemwithan

appropriate brush. If the filters are too dirty, take them out

by means of pliers and clean them.

3 Takeoutthefiltersontheflatendsofthewaterintake

hoses together with the gaskets and clean thoroughly

under running water.

4 Replace the gaskets and filters carefully in their places

and tighten the hose nuts by hand.

5.5 Draining remaining water and cleaning the

pump filter

Thefiltersysteminyourmachinepreventssoliditems

such as buttons, coins and fabric fibers clogging the pump

impellerduringdischargeofwashingwater.Thus,thewater

willbedischargedwithoutanyproblemandtheservicelife

ofthepumpwillextend.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMY 71483 LMB2 in the language / languages: English, German as an attachment in your email.

The manual is 2,29 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BEKO WMY 71483 LMB2

BEKO WMY 71483 LMB2 User Manual - Dutch, French - 38 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WMY 71483 LMB2 Manual

Product: