528055

BEKO WMI 71641 Manual

10
Zoom out
Zoom in
Previous page
1/48
Next page
EN
10
Adjusting the feet
C
Do not use any tools to loosen the
locknuts.Otherwise,theycanbe
damaged.
1. Manually(byhand)loosenthelock
nuts on the feet.
2. Adjust them until the machine stands
level and firm.
3. Important:Tightenalllocknutsup
again.
Connecting to the water supply.
Important:
• Thewatersupplypressurerequired
to run the machine must be 1-10
bar(0,1–1MPa).(Practically,itis
necessarytohave10–80litersof
water flowing from the tap in one
minute to have your machine run
smoothly.)Attachapressure-reducing
valve if the water pressure is higher.
• Connectthespecialhosesupplied
with the machine to the water intake
valves on the machine.
• Inordertopreventwaterleakagethat
may occur at the connection points,
therearerubberseals(4sealsforthe
models with double water inlet and 2
sealsforothermodels)attachedtothe
hoses. These seals should be used
at the tap and machine connection
ends of the hoses. The plain end of
the hose fitted with a filter must be
attached to the tap and the elbowed
end must be attached to the machine.
Tighten the nuts of the hose well by
hand;neverusewrenchestotighten
the nuts.
• Openthetapscompletelyafter
making the hose connection to check
if there is any water leakage at the
connection points. Turn off the tap
and remove the nut in case of any
leakage. Retighten the nut carefully
after checking the seal. To prevent any
water leakage and any other damage
to be caused by it, keep the taps
closed when the machine is not in
use.
• Modelswithasinglewaterinletshould
not be connected to the hot water
tap. Laundry may be damaged or the
appliance may switch to protection
mode and not work.
When returning the appliance to its place
after maintenance or cleaning, care should
be taken not to fold, squeeze or block the
hoses.
Connecting to the drain
The water discharge hose can be
attached to the edge of a washbasin
or waste water system. The drain hose
should be firmly fitted into the drain as to
not loosen in its housing.
Important:
• Theendofthedrainhosecanbe
directly connected to the wastewater
drain or to the washbasin. The
fitting must be secured in all types
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO WMI 71641 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMI 71641 in the language / languages: English as an attachment in your email.

The manual is 5,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info