Manual BEKO WMI 71641 (page 7 of 48) (English)

528055

Zoom out

Zoom in

1/48

an earthed outlet protected by a fuse

of suitable capacity.

• Thesupplyanddraininghosesmust

always be securely fastened and

remain in an undamaged state.

• Fitthedraininghosetoawashbasinor

waste system securely before starting

up your machine. There may be a risk

of being scalded due to high washing

temperatures!

• Neveropenthedoororremovethe

filter while there is still water in the

drum.Otherwise,theremaybethe

risk of flooding and possible injury due

to the hot water.

• Neverforceopenthelockeddoor!

The door will be ready to open just a

few minutes after the washing cycle

comes to an end.

• Unplugthemachinewhenitisnotin

use.

• Neverwashdowntheappliancewitha

water hose! There is the risk of electric

shock! Always disconnect from the

mains by unplugging before cleaning.

• Nevertouchtheplugwithwethands.

Never unplug by pulling on the cable,

always pull out from the plug only. Do

not operate the machine if the power

cord or plug is damaged.

• Neverattempttorepairthemachine

yourself.Otherwise,youmaybe

putting yours and other’s lives in

danger.

• Formalfunctionsthatcannotbe

solved by information in the operating

manual:

Turn off the machine, unplug it, turn

off the water tap and contact an

Authorised service agent.

If there are children in your

house...

• Electricalappliancesmaybe

dangerousforthechildren.Keep

children away from the machine when

it is operating. Do not let them tamper

with the machine.

• Closethedoorwhenyouleavethe

area where the machine is located.

• Storealldetergentsinasafeplaceout

of reach of the children.

• UseChild/Keylocktopreventchildren

altering the settings

Electrical connection

Makesurethatyouhaveanearthedpower

outletsocketratedat13amps(minimum).

Attention!

If you place your machine under a

worktop, the socket must be reachable

after installation, or a separate switch

(whichcandisconnectthetwopoles)must

be used in the installation.

Connect the power cord to the appropriate

electrical socket with an equivalent current

rating indicated on the rating plate at the

front of the machine behind the kick plate.

After removing the plug from its transit

position, please insert the plug seal

to prevent water spillage entering the

machine.

Electrical requirements

Before you insert the plug into the wall

socket make sure that the voltage and

the frequency shown in the rating label

corresponds to your electricity supply.

We recommend that this appliance be

connected to the mains supply via a

suitable switched and fused socket in a

readily accessible position.

Should the mains lead of the appliance

become damaged or need replacing at

any time, it must be replaced by a special

purpose made mains lead which can only

be obtained from a Authorised Service

Agent.

This appliance must be earthed

If the fitted moulded plug is not suitable for

your socket, then the plug should be cut

off and an appropriate plug fitted.

Destroy the old plug, which is cut off as a

plug with a bare cord could cause a shock

hazard if inserted into a socket elsewhere

in the house.

The moulded plug on this appliance

incorporates a 13A fuse. Should the fuse

need to be replaced an ASTA approved

BS1362 fuse of the same rating must be

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMI 71641 in the language / languages: English as an attachment in your email.

The manual is 5,66 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WMI 71641 Manual

Product: