556840
8
Zoom out
Zoom in
Previous page
1/40
Next page
8
EN
3 Installation
Appropriate installation location
Do not place it on a long pile rug or
similar surfaces.
and the dryer -with full load- when
they are placed on top of each other
Place the product on a solid and flat
floor that has sufficient load carrying
capacity!
power cable.
where temperature may fall below
from the edges of other furniture.
Removing packaging
reinforcement
Tilt the machine backwards to remove
packaging reinforcement by pulling the
ribbon.
Removing the
transportation locks
bolts before operating the washing
machine, otherwise, the product will
be damaged.
until they rotate freely (C).
turning them gently.
To make the product ready for use,
review the information in the user manual
and make sure that the electricity, tap water
supply and water drainage systems are
appropriate before installation. If they are
not ,call a qualified technician and
plumber to have any necessary
arrangements carried out.
Preparation of the location and
electrical, tap water and waste water
installations at the place of installation
is the customer's responsibility.
Installation and electrical connections
of the product must be carried out
Manufacturer shall not be held liable
for damages that may arise from
procedures carried out by unauthorised
persons.
by a competent person.
Prior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products cause risks for your safety.
Make sure that the water inlet and
discharge hoses as well as the power
cable are not folded, pinched or
crushed while pushing the product into
its place after installation or cleaning
procedures.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO WMD261 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMD261 in the language / languages: English as an attachment in your email.

The manual is 2,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info